- Kitchen Faucet with Pull-Down Sprayer, Single Handle, Matte Black

I usually buy name brand on high use faucets, but our kitchen sink Moen unit's insides literally rusted and stained the stainless steel sink (luckily, under the hole cover plate) - so I don't see the sense in paying $150-$200 for Moen or Koehler. For $45, this Arofa high arc faucet was a seamless replacement, and - in black - it looks really nice against the stainless steel sink. I very much like that the water supply lines are standard stainless steel braided, 3/8" fittings, so I didn't have to get braided lines at the box store, and there are no add'l joints to leak between the supply and the faucet (this is probably standard today, but the Moen it replaced required separate supply lines). One oddity, not a problem, but the 3/8" fittings tighten with a 17mm wrench, most 3/8" fittings tighten with a 16mm. I also much prefer the drop-down sprayer style to the Pull-out-of-post it replaced. The pull OUT style angles *DOWN* into the body of the faucet post, allowing water overspray to trickle into the post. The Moen was replaced because it would barely rotate anymore - it's inner works were rusted completely away, nothing left but a handful of red grit. The pull DOWN sprayer style pulls out of the end of the arc, any overspray would have to travel *UP* and over the arc to get into the faucet body. Much better design. I like that the sprayer hose is covered in a braided stainless steel covered with some kevlar-ish stuff. It slides easily. The moen's uncovered braided steel abraded and unravelled. Installation was trivially easy once the old faucet and it's bits were out. Feed the lines and the threaded section through the 3-hole cover plate; from below slip the large ABS/brass threaded ring over the lines, and hand tighten onto the faucet threads. I'd prefer to wrench tight, but the large ring is clearly designed to prevent over tightening. Attach the braided, color-coded supply lines to the existing 3/8" supply fittings. Clip the sprayer weight to the marked position on the sprayer cable. Turn on the water supply, and you're done. I like the look of the 3-hole cover plate, which has a thick waterproof pad, but I don't like that it is held only by the faucet body & hand-tightened ring. The cover plate it replaced had threaded posts sticking thru the unused holes, which tightened securely to the underside of the sink. Without these, it's too easy to move the cover plate. In the end, I applied plumbing cement to the underside of the plate's soft pad and tightened that securing ring as hand tight as I could get it :-) It can move, still, but it's solid. ONE NOTE... if you existing water supply pipes don't have 3/8" compression fittings... as many older houses don't... *and* you have the option of replacing the supply valve... I'd really suggest replacing the existing multi-turn valve with a 1/4 turn 3/8" comp outlet fitting, directly to the supply pipe (in our case, a 1/2" copper pipe, so a 1/2" compression inlet fitting). The multi-turn valves are horrible sources of leakage. The EASY way is fine - a 3/8" adapter to whatever your supply requires, but is an add'l source for leakage. If your wall pipe is 1/2" copper or 3/4" MIP (threaded pipe), replacing the valve is not beyond most homeowners SO... for a quarter of the price of the faucet it replaced, I'm really happy with this faucet. It looks good, is not leaking, and was easy to install. Time will tell whether it holds up, but it looks and feels solid. All the fittings and supply lines are good quality, all the important parts are 304 steel, all the moving parts move easily, but feel solid. We paid full AMZN price for this item - no compensation for review.

This is a wonderful faucet! It looks great, works perfectly, good pressure and does not leak! It was very easy to install and the installation system it uses will be very easy to remove it I ever decide to replace it in the future. I am very happy with this purchase

Love this faucet. Did a kitchen renovation and came across these on Amazon. Husband was skeptical because of the price but I read the reviews and that help to make the purchase. Got them. Love them. Great color. Great value. Very durable. Perfect height and no leakage and easy to clean up. Would definately recommend this product. Nice and sleek look

The metal is a bit thin, and the water pressure is a bit lower than what I like, but overall it is a good faucet and it works well. Easy to install. Great value for the money. Update: after using it a few days, the pressure is fine. I just had to get used to it. I even reduce the pressure for hand washing to lower the flow. It has a button to stop the water flow entirely also, if you like that. Overall nice.

Like so many others have commented, the hassle was getting the old faucet off. I live in a 5th wheel travel trailer and it has 1/2" pvc pipes that go all the way to the counter. The new faucet comes with its own hoses, so it caused an issue with my long pipes. Anyhow, I worked the pipes around to where I get the hoses on. One problem, the ends are not a regular 3/8" but rather 3/8" compression. So I emailed the company to get more info on the type of connector. In the meantime I ran to Ace Hardware and got the proper 1/2" male to 3/8" male compression connector. Go back, get everything hooked up, turn on the water & the hot water hose is leaking badly above the connection. No amount of Teflon tape or tightening helps it. By then, customer service responded. Faster than I thought I will admit. I explain I found out about the connection type but explain my issue with the hot water hose. I provided a video of the water spraying and sent it to them. Within a few hours, they respond back. New hoses will be sent. In the meantime, I go to put my old faucet back on but discover the old pvc pipe had cracked by the connection. Ugh. So back to Ace Hardware I go and they hook me up with water turn off valves that have the 3/8" male compression end. It cost me more than I anticipated but we'll worth it. The shit off valves clamp on, no glue, no fuss (I went ahead & cut the pvc pipes down & bought 2 hoses to go from shut off valves to old faucet) Anyhow, a couple days later I get a package. A large, heavy package. They just sent me a new faucet. Wow, so cool. Needless to say, after fixing own connections underneath, it only took about 10 minutes to get the old faucet off and new one on, if that long. The faucet looks great, works good. Yes, I have a wandering plant behind it, so I've got the handle at an angle. But that can be adjusted easily. The sprayer is nice, I've been wanting one. Comes in handy. Overall, very happy with the faucet (gives me better water pressure too). Extremely happy with customer service. Would definitely highly recommend

Beautiful faucet, very easy to install myself.

Actually, for the price this faucet is very nice. It was fairly easy to install however, I did have a plumber do it. I like the brush chrome finish and it is not too chunky.

The faucet works really well but this last week the faucet lost water pressure after a little over two years of use , so I connected the company that makes them and asked to use the five years warranty . I was help right away by a lady called Vivian , she was really helpful and understanding of our situation and ordered some parts that could fix the problem, After the parts arrived didn’t fix the problem and I contacted Vivian again , She was ready to help us and send us a new replacement. This company is serious about their products and customer service , I would recommend their products to anyone. Thank you !

Die Überwurfmutter passt nicht auf mein 3/8 Zoll Eckventil. Für 1/4 Zoll ist das Gewinde allerdings zu groß. Entweder hat der Hersteller ein völlig untypisches 5/16 Gewinde (oder irgendwas dazwischen) reingefräst oder die Fräse wurde nicht richtig eingestellt und/oder das Gewinde für 3/8 nicht richtig fertig geschnitten. So oder so ist das so nicht ohne weiteres montierbar. Die Mitarbeiter in einem namhaften Fachgeschäft waren auch relativ ratlos und konnten mir kein passendes Reduzierstück verkaufen. Somit geht die Armatur, die an sich mit einer ansprechende Anmutung daherkommt, leider zurück. Nachtrag: Ich verbessere die Rezension von 1 Stern auf 3 Sterne, weil mir der Hersteller des Artikels versichert hat, dass er sich die Kritik zu Herzen nimmt und die Armatur künftig mit einem kompatiblen Anschluss ausliefern wird. Die Kommunikation war zudem überaus freundlich und zuvorkommend.

It got broken (the stainless steel part joining the base with the pipe at top of the sink) less than 20 days after fixing ( not sure if there is a warranty - but no time to chase seller - also it was not always retract and loose and water pressure was too low ( very bad quality product and i dont recommend Unfortunately going again to buy another pipe and pay another installation charges

Excelente calidad

سهل التركب وعملي وسعره مناسب وشكله في مغسلة المطبخ مناسب جدا

Wasserhahn wird mit 1/4 Zoll Anschlüssen geliefert! In der Beschreibung bei Amazon wird dieser mit 3/8 ausgewiesen. Leider habe ich den Hahn erst mühevoll montiert und mich dann umso mehr darüber ärgern dürfen dass dieser sich nicht anschließen lässt. Auch Marken Bauhäuser haben keinerlei Adapter. Auf den Bild zu sehen links der kleinere Anschluss rechts der deutsche Standardanschluss! Ich habe mich daher entschieden den Hahn zurück zuschicken. Ansonsten macht der Hahn einen hochwertigen Eindruck, obwohl an einer Stelle die Legierung angekratzt war. Der Hahn ist sehr leicht, mein früherer und jetzt neuer Hahn von HansGrohe ist dreimal so schwer und steht deutlich standfester. Der Hahn kommt aus LasVegas daher dauerte der Versand 2 Wochen.