Edge Supply Birch 3/4 in x 50 ft Roll – Pre-Glued Iron On Wood Veneer Tape – Wood Veneer Edge Banding Tape with Hot Melt Adhesive, Smooth Sanded Finish Ideal for Furniture & DIY, Made in USA

This edge banding is fantastic—super easy to install and delivers a clean, professional finish. I’m really impressed with the quality. Highly recommend!

I ordered this wood veneer tape about 6 months ago and used it on a project with great results. It ironed on easily with not issues and trimmed up nicely after letting the edging cool down a bit. I will buy this product again from this seller in the future over other sellers. Since this project, I have ordered from others as the price was cheaper. It's true what they say, "you get what you pay for". Other products were taped together to make 50 ft and missing glue throughout the roll. Great product!

Easy to use and looks great. Adhesive feels strong but allows a time set the edges nicely in place before permanent bond.

This is a great way to dress up plywood edges, but there are a few things you should do to make installation easier and cleaner. 1) Leave a small amount overhanging the edge. As you adhere this down the length of the board, it will pull a little. If you start flush with the edge, you'll end up with a gap. It's easy to trim later. 2) Be mindful that this can shift as you install it, so use your fingers as a guide to keep it from hanging over the edges too much. BUT, be careful not to move your hand too quickly as this will slice your thumb or finger open. Imagine the worst paper cut ever...now dump some splinters into it. 3) Once it's installed, it will need to be sanded to be flush with the edges. It's just a hair wider than the plywood it's for (depending on your plywood supplier). The problem is that sanding it right away will cause the small amount of excess glue to gum your sanding pad, then heat up and reapply this mass to the side of the wood you plan to finish. Oops...say goodbye to staining options! So, before you sand, use a razor or box cutter to run down that beat of glue and remove as much as possible before sanding. Also, if you sand at an angle and keep the pad from laying flat on the finishing surface, it will reduce the potential for glue spreading. 4) Finishing the leading and trailing edge is very easy. Use a box cutter to score the tape, bend it over the edge and it should snap. Then a quick sanding should make it perfectly flush. It's easy to install. Easy to stain. Makes the use of plywood for finished products much easier. This is just a great product that, with just a little practice, offers a fool-proof solution. Oh yeah, TURN OFF THE STEAM on your iron if that's what you're using!

Works like it should. The glue holds up. Just have to make sure you get it evenly hot. Plenty of material to trim down to 3/4”.

Sound quality. Easy to apply

Excellent quality. Works great.

This product is amazing. Actually sticks long term, looks great, and so easy to work with. I’ve purchased more to have a great stock of this stuff. Everything is as advertised and the use leaves a perfect finish. Makes it look like a solid wood build!

Beautiful product

Easy to work with. Still looks great even after 6 months.

Quality birch edging Fits 3/4 inch plywood almost exactly only a small amount to trim

I have used this on a project at home to finish the edge on a few pieces of birch plywood used to make a corner sitting area in the kitchen. Easy to apply using a hot iron and the glue adhesion is great. finished it off with a white stain and clear satin. matches perfectly.

Easy to glue and mostly blemis free.