USG 280070 2 Way Pla-Cor Cap

These outside corner caps work great, saves a ton of time, finishes very clean and looks great! Did some remodeling around on a utility room, replaced two doors with sliding doors and had to finish the entries. I used 3M Corner Bead 61 Adhesive to attach them, then used a staple gun to keep them in place while adding the corner round strips. I learned quickly you need to trim the sheetrock edges to ensure the caps and corner round strips fit flush to the walls. While these are expensive, the time saved and finish is worth it.

not aluminum its plastic value about $1.25 rip off

The cap was a bit smaller than the bullnose corner bead it was connecting to so I had to apply extra joint compound and sculpt/sand it to match.

A little pricey for one but only place I found that will sell small quantities. Other than that works perfectly.

They were too small, couldn't use, returned

Used 3M spray adhesive, no nails or screws required. They really make those Bull-Nose corners look good! They accept mud and paint well.

Junk

Worked like a charm