Wood-All Maple Wood Veneer Sheet, Plain Sliced/Flat Cut, 24x96, A Grade, 10 mil Peel and Stick PSA Backer

This worked out very well for me. The veneer has a nice clear grain. That 3M pressure sentive adhesive makes it hang on like a scared monkey. I apply it and then use a rolling pin on it. Yup, a kitchen rolling pin. One thing I did notice was that the grain is very tight and so trying to match stains is tricky. The stain does not penetrate as deep unless you use several coats. Like the difference of sanding to 400 as opposed to 120. That aside, I would not hestitate to use this veneer again.

I covered a dresser top because I wanted a real wood finish and didn’t want to try stripping the glossy paint job someone else had done before me. I sanded the top and edges before VERY carefully laying down the veneer and removing the backing. (Wish I’d had someone help me, but it worked, nonetheless!) (Then I used iron-on veneer for the edges) Sanded the corners and edges and stained and varnished. The adhesive is very strong! The veneer takes stain and varnish very well. I’m thrilled with the outcome.. I’d definitely use it again! I’d only suggest finding a partner for larger projects since the adhesive is so strong, and you CANNOT make a mistake!

I bought several of these for cabinet refacing jobs. They all came with glue stuck to the face of the veneer where the inside roll touched it. It cleans up easily with Acetone, or Adhesive Cleaner. The problem with wrinkling comes from the liquid used to stain or finish the veneer. I was able to work around it because I was cutting small strips. If you are staining the material you should try to find Wood-on-Wood veneer. This will not wrinkle

This veneer is thin and strong and great for covering large sections of cabinetry. One caveat... I stained and varnished prior to cutting and mounting on cabinets. Small sections 1'x2' were fine. But large sheets ca. 8'x2' were very difficult to mount as the stain and varnish had caused the veneer to warp. As a result I trapped many air bubbles underneath the veneer that had to be vented with a pin hole and beaten down. Would have been much easier to cut and mount first, stained and varnished thereafter.

As a "back-porch" woodworker, I was hesitant to try applying wood veneer. Once before, I used a veneer requiring contact cement and admittedly made a mess of it. This Pressure Sensitive Veneer, however, was amazing. Cut it, peel and stick, apply pressure, trim, and done!! It was so easy, I was amazed, and the results were gorgeous. My project was an old cedar trunk that had been damaged by too many years in storage, and I am just thrilled with the results!! I'd buy it again in a heartbeat.

High quality veneer sheet with 3m backing. This company's product is light years ahead of the product that Edge Supply sells and the price is much cheaper.

The veneer itself looks great, but this was spoiled by the line of adhesive glue that was on the surface where it was rolled up, and worse there is a 1-1/2 strip along one edge where there is no adhesive backing rendering that portion unusable.

I'm really impressed with the adhesion on this veneer. Just make sure you install it properly the first time because it is very difficult to remove. Takes a stain well too. I'm pleased.