Project Box IP65 Waterproof Junction Box ABS Plastic Electrical Boxes DIY Electronic Project Case Power Enclosure with Fixed Ear 7.87 x 4.72 x 2.95 inch (200x120x75mm)

Well constructed, robust. I used it for an electronics project (Garage door opener using clicker and dry contact zigbee switch)

Needed a quick project box that could be mounted on a wall. This worked great, and was easy to modify for the wiring and internals.

Used this clear-top weatherproof enclosure as the junction box for a dusk-dawn outdoor LED deck stair lighting sensor. Sunlight through the polycarb lid works fine. Hope it lasts a loooong time.

I have an 04 Dodge Ram, converted to an electric Flex-a-lite fan with a control module. Problem is, there's nowhere great to mount it near the radiator, so it's exposed to the elements. This project box was the perfect size to contain the controller. You will have to drill holes in the box to run wires in and out, but I imagine most people will realize that going into a project like this. My one gripe would probably be mounting the controller inside the box. I had to experiment with several different short screws and angle the controller a few different ways to secure it properly. My suggestion to improve this box would be more mounting studs on the interior and maybe a recommendation on what size screws to use (I think I used something like a #8 x 3/8" wood screw).

My balancer for my LTO battery bank this worked like a charm. A little cutting for the wires and it's see though you can see my balancer. It will look real nice on my huge battery box.

Size worked for my application. Used a 2" hole saw in the cover to mount two analog gauges. Also four banana jacks on the top side.

left the wrong review earlier. Everything as expected. thanks

Great box. Used it to build a sprinkler controller using a raspberry pi 2w and own software. Just the right size for my 8-port relay board and pi.

This box is very well made for the money. The top is gasketed! and all the screws for the top feed into brass inserts which are moulded into the box. There are also extra brass inserts in the box for mounting equipment.