ITBEBE 50 Pcs - RJ45 Cat6 Cat6a Pass Through Connectors for 23 AWG Cables - 50 Cat6 Passthrough Connector Ends and 50 RJ45 Connectors Clear Strain Relief Boots for Clean, snag-Free Ethernet Patch Cord

A must have if you do any type of custom Ethernet Cable runs. I've used this same brand for years at work. I must have made 1000s of cables. The only time the cable failed after testing was because the proper wiring sequence wasn't followed. It never failed because of the connector. The pass trough makes it so much more unproblematic to see that your wires are in the correct order, and if the wires are sticking out, it's long enough. Many fails from other types where the wires must bump up to the back wall inside. Multi-color boots make identifying cables easy and helps save the cable as well. Hint: Purchase a Pass Through RJ45 crimper as well, saves time trimming excess wire.

This is the kind you want to use if you make cables occasionally (make sure you have a cutting tool) If you make cables every day the blind end connectors are slightly cheaper... but not much. If you make a cable every week or two then these will be cheaper because you can make sure your wires are correct before you crimp saving the cost of the mistakes.

I have been doing IT for about 20 years now and I can make some nice cramps, but with these ice cubes, I make pro cramps all the time! It takes some getting use to, but we'll worth it!

Easy to use. Work as described. Older crimper tool doesn't cut wires that pass through, so extra step to trim wires if without newer crimper.

Good value for the combination of the jacks and boots together. The pass through jacks work great, easy to pass through the heavier CAT6 cables and keep twisted closer to the jack. I’ve used on both solid and stranded cable, both worked good. Pass through is the way to go, though you do need a special crimper unless you want to manually trim the ends.

Bought these for CAT6 cable, and while the connectors are perfect, the boots are too tight to fit over the wire. I suppose I could hear the boots or use lubrication, and I may try that. But for now my cables are bootless.

I love the finished product once everything is terminated. They look and work great!

Is about every 3rd connector the pins would fallout. Overall not too bad have had worse. These are not good for using shielded cable a salmon withey solve them with the cable ends but they don't work with a thicker shielded cat 6A cable that they describe it as Is very unhappy would not purchase again