Oregon Permatex 80022 Sensor-Safe Blue RTV Silicone Gasket Maker, 3 oz. Tube

I’ve been using this product for 30 years…It works to secure a gasket to anything that gets exposed to high temp heat…Stuff works great and actually works like a tacky glue when setting a gasket in place or can also be a gasket. I’ve used it to adhere the rope style gaskets on my wood stove, never fails and doesn't smell after it’s dried 24 hours to fully cure…The heat doesn’t melt it or cause any odor issues. Highly recommend it…I also used the orange one made by the same company which is also a great product for seals or anything water related

Good gor better coverage with existing gasket and can be used in place of some gaskets. I have used this on small engines and vehicles along with pump repairs on pools. Always works great and lasts a long time if you keep the cap on and clean out the dispenser tube after each use.

Works perfectly

The product is fine not sure why the seller only sent me one when I ordered a two pack

Recommended. Great product. Good Quality. Exactly as described and expected.

Used it to augment my '03 Corolla's new valve cover silicone gasket. Difficult to squeeze tube (lots of strength needed) and still have a still hand to apply a straight line of material. Found it was easiest to use sliding clamps to gently apply lots of pressure to the tube to squeeze out content so I can focus on precise strain line. Steps are, clean up old gasket materials (this took me days), apply to up-side-down cover, then insert gasket, clean excess with acetone, apply another layer on top of gasket, place on engine, hand tighten bolts, and after 1 hour can bring to correct torque according to packaging. For '03 Corolla S, all are 10mm and Torques specs are as follows: centered 2 bolts = 96 INCH lbs, perimeter bolts = 80 INCH lbs (note there is 1 unique bolt on the driver side-most front; this bolt goes through the engine shroud). Good luck and happy wrenching!

I understand that this can be used as a standalone gasket, but I've never used it that way. I've always just added a very thin application to each side of a hard gasket to help them seal. I've done 4 water pumps in that manner, and every one worked out great. Do read the directions though. You're supposed to apply it, install the parts, lightly tension the bolts, then wait an hour to torque them to specs, and 24 hrs before subjecting it to use. Be careful how you store it too.. crank the lid on tight and put it in a ziploc w/ all the air pushed out. Will keep for a year or two.

This is one of few products I've used that produced excellent, long lasting results. I over did it the first time and ended up with a mess. When I used it correctly as directed, I got a perfect, non messy, long lasting seal. Most recently, I used this to seal the connections on my hot tub heater. The stainless steel to PVC connections are neat, leak free and easily handle the heat.

Good

used to seal tire to rim on honda 3 wheeler worked great

Easy to apply and stopped the oil leak

Shows up on time and works great

注文した宅配物をあけたらパッケージが破られ先端だけ盗まれてた。梱包する際チェックしてるのかぁ？梱包する際盗んだんだろうな。すぐ交換手続きを行ったが、交換の手間を考えると新しい物を送って貰いたいくらいだ。