J-star Extra Large Fish Breeder Box for Aquarium Tank, Acrylic Breeding Box for Guppy/Betta/Shrimp/Clownfish, Baby Fish Hatchery & Isolation Tank

I breed platy fish and this box allows the fry to get away from the mother after birth. It does exactly what it is ment to do. It is also very easy to clean when not in use. I have not used the splitter yet but I will when I breed guppies.

It has a couple open tube like areas that my fish keeps getting stuck in so I can’t use it until I plug the holes up

Well protected for shipment

This is so flimsy I doubt it will last a week the suction cups are too small to hold it to the glass and it was dirty like it was covered with a fine sand

I bought this as a replacement for another breeder box. This worked get when the snails hatched. I struggled more than I should have to clean the breeder box. So far so good, hoping my stubborn guppy will give birth in this box.

I had two pregnant guppies. I put one in each of the upper sections and they each had their babies. A few of the babies stayed up with the mom but most of the babies dropped down below when I found them. It was easy to remove the upper portion of the box to allow the babies to have the full box and the moms went back into the large tank.

Good idea bad design how to seperate the two halves without taking it out of the water impossible

Very good for my guppy baby fish .