2500mm Bicycle Hydraulic Disc Brake Hose Complete Kit for Shimano BH59 System Included 4PCS Lever Covers, 4PCS Compression Nuts, 6PCS Protective sleeves, 5PCS Oliver and 5PCS Inserts (Black)

Worked great for sons e-bike which we upgraded with shimano mt-200 brakes. Easy to cut with a blade or scissors ( as long as it’s sharp). I needed a longer front tube than was supplied with the brake kit so bought this and cut to fit perfectly. The supplied hardware seems as good as the shimano ones. To install the ends you need to place the end of tube in a vice or hold very firmly with a vice grip or locking pliers on edge of bench table and hammer the brass fitting in to the tube. It’s a tight fit but does go in! Once the brake oil has been filled/bled, we experienced no leaks and they work just the same as the shimano branded brakes. Great value for money and would buy again if needed.

I upgraded my e-bike to hydraulic brakes, but the stock line that came with the kit was too short for the rear. This was my solution and it’s was a perfect fit. It was my first time replacing a hydraulic line but I figured it out. I will definitely buy again because I have future plans for my bike. I will post pictures later.

Works great, fittings don’t leak

This brake line is a good replacement line of you need to extend a line or replace a damaged/broken line. The brass olives and barbs are easy to work with. The length is more than enough to be run internally on most bikes and still have enough to fix a front brake line if needed.

This brake line worked great. I raised my bars and had to extend the front brake line. I did not use a tool to insert the brass fitting. Warm the hose up with a hot air gun and hammered it in with a small hammer.

Kit has everything you need to assemble a front and rear set of MTB brake hoses. Priced much better than comparable kitsch and r2ceived it next day.

It it did the job I needed it to do but it's very very stiff if it was more pliable I would have given it a better rating.

These are advertised to be BH59 compatible, however I compared the hole diameter of the insert to my original inserts and the diameter is much smaller. I tried to use them anyway, and I could not get the brakes to bleed. I had to go out and buy the correct BH59 insert and after that they bled perfectly. Beware

This kit worked perfect for an MT200 brake system. No issues or complaints.

Good quality set for bikes with disc brakes.

Good.