Crazepony 4pcs 6x15mm Motor (Speed: Insane) 19000KV for Blade Inductrix Tiny Whoop Micro JST 1.25 Plug

These motors are fast I could see a big difference right away the only problem was that my plugs or their plugs not sure which one were backwards so I had to flip the wires of th ccw motors at the plug which was very simple

So, I have this self-flying drone purchased for the grandkids. Worked very well but with a bit of abuse one of the motors crapped out. After some measuring of the original motors I found these that appeared to match what I have, ordered them up, arrived looking good and were installed. The value for the money is very good. The 5 star easy to install description is accurate for me but if you're not experienced with dismantling small electronics like a small drone and doing some soldering on a small scale to install all four motors then it may be a bit more tedious than expected. But the drone is back in the air.

Ordered the wrong motors for my drone but still good motors maybe I'll get a drone that uses this size of motor or even use them for something else later on.

I had used these motors and the 17500kv ones before but I had a car accident a d left with a spine injury then my father passed so I gave my cousin my tiny whoops.Well I decided to build a few and fix a couple I had sitting around collecting dust.I bought an Blade inductrix fpv pro board,a 65mm cockroach frame and used 3 blade German props.WOW!!!!Tons of power,it's super fast but yet smooth.I ended up changing the connector and bought some 1s HV lipos.Smashing this thing In the air looking like a hummingbird on crack.These motors can't be beat for the price.I highly recommend these motors for your tiny whoops.I also bought an inductrix fpv board slapped on these motors and a fpv micro camera and these motors have no issues carrying 28.40 grams with plenty of oomph when needed.I bought extra to keep as backups.I hope they never stop selling them at this great price.

I have a blade inductrix that the factory motor ripped the wire out on a crash. I purchased these to replace that 1 motor. good thing it comes with 2 of each since the first one I went to put in fell in half. I put it in about 3/4 way into the frame then put the prop on and used the prop to push it all the way into the frame. I have done this many times swapping frames that have been destroyed in crashes. While pushing it in, the entire bottom of the motor fell out and ripped in 1/2. I through that one away and did the exact same thing to the next one. this time it slid right in like expected.. not sure if I got a bad one or if they are all built like that?

Used to replace a failed motor on a Veeniix V995, no problems so far.

These are good motors for the price. Ive purchased motors that cost more and are at higher rating, they perform about the same. This motor gives you more thrust enabling you to increase altitude faster or recover from a flip. It can help with cornering as well since the motors are very responsive. One thing to keep in mind is that your flight time will be reduced. My times reduced by 35-40 seconds which is no big deal to me. I usually get 4 minutes with 14k motors but the speed is a boring 4 minutes. HV batteries may help increase it but if you are satified with a bit shorter flight times then hv might not be required. Ive purchased several products from Crazypony and not one has given me any problems! Definitely getting more parts from them when i need it!

They need a pretty small prop and they will get very hot if the prop is too large. They are extremely light weight and work fairly well. Given 4.2 V They draw around 2 amps at stall and 0.1 amps under no load. The only drawback I had was 1 of the motors gave much more power than the others needed to regulate this in the programming.

Only two pieces motor received, missing others two.

Did not come with the connectors! Not as advertised!