Hooshing 4PCS Garden Hose Connector 1/2" Barb x 3/4" Male GHT Thread Solid Brass Repair Kit Male Hose End Mender with Stainless Clamp Fit for 1/2" Garden Hose

Worked great for the 3/8 inch hose for my fountain. One comment though. It was difficult pushing it into the hose. I had to heat it with a lighter. When it became soft it went in. Then I screwed the sprayer on it. kept me from having to buy a new hose

Works great

They work well and at a good price. Much better and more durable than plastic.

Good brass fitting. Hose clamp only useful for very thin walled hose.

Bought these for Winterizing the RV. Attached a clear vinyl hose to siphon RV antifreeze into the system. works great.

Used these to adapt a water feeder system for my garden. The plastic ones were not holding up. These have enough quality to last forever. A perfect fit and no leakage.

Seemed like a good product, but had problems getting clamp tight enough to prevent leaks. May try some rescue tape or teflon to tighten the seal. Seems to be built with quality. Too bad it didn't work right out if the box.

These worked to repair an old hose that had a cloth sheath.

Did what it was supposed to do

Brass ends are good quality and worked perfectly. However the clamps are really cheap. They will corrode in about 3 months and they kept unscrewing with pressure, had to continue screwing them each time I opened hose. Replaced them with higher quality clamps from another vendor, no issue after that.

Excellent fittings for pond 3/4" kink free tubing to 3/4" hose

Excellent product

These are made of pretty cheap materials, one of the o rings looked like it had been used before and had a hairline circular cut all the way around it. Needless to say that one leaked. Becuse the materials are cheap, it's hard to say it's a one off, but it might be. Either way, because I needed two I had to spend more to buy another o-ring and silicone it just to be sure. Might be better to spend a little more for higher quality products.