Flutesan 20 Pcs 3 Pin 10mm Solderless LED Light Strip Connectors Clear Track Lighting Connectors for 5050 RGB Strip Light

Worked great

I needed to solder 30 LED segments together for a project, which I was not looking forward to. These turned out to be a great alternative. There are wire guides that fit 22 guage wire perfectly (without stripping) and hold everything in place. On the other side are pins that pop through the copper LED pads to great a secure connection while preventing the LED from moving. If you make a mistake, these are easy to open, too. I just wish they were a little smaller (a need for my project) and more came in a pack. I have had to buy 3 packs. All in all, these should hold up as long as solder would with no fumes and no costly mistakes (like removal of copper pads, which can happen when soldering LEDs)

I intended to use these fasteners on IP67 outdoor LED strips and they worked fine and pierced the silicon with no problems. I did have an issue when I moved the strips to make adjustments in their placement. They grab onto wires and strips very well but the closures can pop open when moved. Ensure your placement and use care when moving.

Facilita tus conexiones con luces led

it's easy to push the copper lands of the light-strip past the "teeth" of the connector. no biggy. Just be careful. However, the images include a photo of the connector being used to connect wiring to the light strip. and this may be theoretically possible but practically impossible. There is nothing to keep the wiring aligned with the pins as you close the gates. And you have to keep three wires aligned. Good luck. This purchase was to make connections more reliable for high-school students that need to do this frequently. Soldering is still easier and better.

It's been said that the product doesn't fit in aluminum channel. This product fit my aluminum v channel. Rather tight. But, I was still able to get the diffuser on with no issues. So Super Easy to install. I have used 4 out of 20. All 4 worked flawlessly. Didn't scap a single one. UPDATE: used 10 of 20. Works as intended. No issues.

Worked great! I ordered these for a 3D project I printed on my K2 Plus.

The connector works well on the half that connects to the led strip light. The other half of the connector can only be used for very thin wire like cat5 wiring which is 22 gauge. Wiring with heavier gauge or 22 gauge with even a modes amount of insulation coating will not even come closet to fitting in the connector. I suggest you try a different style connector.