2PC 5x100 or 5x112 Wheel Spacers 1/2 Inch (12mm) 57.1mm Bore (NO Lip) with 14x1.5 Extended Bolts (40mm Shank Ball Seat) Compatible with Audi VW A4 A6 A8 S4 S6 S8 Golf Jetta Passat

I ordered these for my 2005 Golf GTI. The spacers did not fit perfectly at first so I had to slowly sand the wheel hub evenly to get the perfect fit. One of my spacers were cracked and they gladly sent me a replacement. If the wheel spacer does not go on easily and then you put on the wheel, you wheel crack and break the spacer like other reviews we’re saying.

Worst quality product I’ve ever received from this website. My wheel literally fell off. They don’t fit. Just buy name brand and save yourself the headache.

Had these for 3 years now no probs no rust, goo buy.

Product seems to be of decent quality but does not fit my 03 GTI despite what the description says. The recess for the hub is not machined(or cast?) deep enough to fit flush against the mounting surface. For anyone who may not notice this during install, it could cause some serious issue or harm. As stated in other reviews, the included lugs seem to be fairly low quality belatedly on the threads and finish.

lugs seem really good quality but there was a weird rust spot in the threads of all of them in the same exact place. threads are all smooth though. Socket side of the lug is very well made/shaped. these are 10x better than my ecs tuning spacers. spacer its self is . . well. . a spacer. hub bore fits nicely. Not too much play but enough for me to know they wont be stuck on in a few weeks. nothing really to complain about so far.

After a severe wheel wobble, I had my mechanic inspect the vehicle. He found what appeared to be a bent wheel hub, after replacing the bearing and hub, that wheel still wobbled. He then discovered the spacer itself was not flat causing my camber and toe to move in and out as the wheel rotated. Crap wheel spacers. With the stress from the spacer not being flat, the hub centric lip on the spacer broke off. This is a 3D printed wheel spacers as well, meaning they are not created with strength in mind. Heat may have caused the spacer to warp or the spacer may have just been manufactured incorrectly. Wheel spacers should be billet, meaning made from one solid piece of aluminum and lathed to its desired size and construction. 3D printing wheel spacers is for show or for wheel fitment purposes ONLY. Do not drive on these wheel spacers. They are unsafe and in the long run, not worth the money. YOU GET WHAT YOU PAY FOR.

It appears to be good quality; the center hub is a very small diameter and would not fit my Audi (not even close). I did use other spaces to get closer to my offset and wound up using the lug nuts that came with the kit. I would recommend you go off measurements only not the item description. I did save them but not sure I'll ever own anything with such a small center hub to use them on.

Perfect fit. Only problem was having to torque multiple times after installation.