KASTFORCE KF2001 Universal Mobile Base 450Lbs Loding Capacity Make Your Tools & Equipment Movable

Easy to maneuver and lock in place very nice inexpensive cure for dragging the saw from storage to place to work! Good product for the money!!

I bought it to hold my Wen planer, and it has been pushed all over my garage since. The only drawback is there aren't enough support rails to make it sturdier.

I really like this product makes my life easier

I purchased two of these. I was unable to use one because it was too small for the piece of equipment I bought it for. The other was used on my Rikon 10-326 bandsaw. It was a tight fit, but it worked out. The base itself is quite weak. It does roll fine, and it does have leveling feet, but they are quite flimsy. If the rear wheels were a little smaller the saw would sit level without use of the feet.

Extremely strong well constructed.

It works well. It would get five stars if the rails were a little longer. I had to add some 2x4 in the middle to elongate one side.

WORKS FOR MY HEAVY TOOL

Avoid unless you are willing to rebuild. Does not sit level when assembled as received. The two repair options are to replace the supplied fixed casters with smaller diameter wheels or cut and re-weld the swivel caster brackets in a higher position.

Assembly instructions were not too clear. I had past experience with similar products so worked out the details. Once assembled it was able to support a 16" industrial planer that weighed about 300 lbs. Biggest challenge was rigging a series of levers and supports to lift the tool up and slide the base under it.

perfect for my bandsaw

Not happy at all with this item, it’s very out of level , the turning bolts are Mickey Mouse poor engineering the tab that holds the turning bolt which will bend if the weight of the equipment plus pushing , I was expecting a foot lever that pushing down a more robust foot , I can’t see the little foot lasting long . This mobile base is only worth $25.00 chincy not worth my time to take apart and ship it back. It’s just on a 14” bandsaw , the leveling bolts will just bend right off if it was a table saw