EAU60710801 EAU62043401 Dishwasher Drain Pump Motor(OEM) by Techecook - Replacement for Ken-more & L-G Dishwasher/Dryer - Replaces 4963038 PS12742537 EAP12742537 EAU62043403 ABQ75742501 EAU60710802

Great fit and works as it should. No more noise and error code gone. Its a simple repair but very limited space to work with. I took each screw out from each side of the dishwasher, slide it out a little bit and then lifted it from the bottom and tilted it slightly back and placed a wood block under it. That gave me plenty of clearance and the job was much easier. Also used a wide opening set of water pump pliers to turn top half of pump clockwise to remove it. Also, much easier. Total job was about 20 minutes. Hope this helps.

Easy install. Repaired the issue.

So far so good. I installed this pump about 6-months ago and so far, it's working perfectly. I would say it's no louder than the original pump, so that's awesome. Installation was very easy and it seems to function (drains water, easy to clean when needed) great. I really appreciate the build quality - seems to be very well made and is durable. If your pump is out of going out, replace it yourself! I was quoted something like $150 to have someone do it for me, so it just makes sense to buy this part and do it yourself.

This drain pump motor was easy to install, fit perfect. The dishwasher ran it's cycles with no more OE code. It has worked for four cycles so far, no issues. Just be sure to re-use your black o ring from your old drain pump.

This is a perfect replacement for LG dishwasher using this type of drain pump. It does not come with the water seal gasket, so you need to transfer the old gasket from the old pump over to this new one. And this is an important tip, flip the gasket to use the un-used side to face the pump mounting outlet. If you use the previously used side, water will leak since there are imprinted lines which create water channels (not completely sealed). Good luck and fun DIY fix. PS: There is a version of this drain pump from the same company that comes with the gasket but it costs more money, maybe it is worth it.

This got the drain working again on my dishwasher. It was a very straightforward job. Only needed a pair of adjustable pliers. It's lighter than the original motor, but it works like a charm. I think it's just as quiet as the one I replaced. I used the original gasket and have yet to spot any leaks after running three cycles.

Had an issue with a high-pitch whirr from dishwasher and the water would not drain from the unit. It would not drain when selecting just the drain cycle either. Turned out to be the water drain pump, and this pump motor fit perfectly. Entire job took about 60 minutes to drain the water out, replace, put back together etc. Next time would likely be a 15min job. Dishwasher back up and running, will update if this part fails.

Worked fine for about a month, then woke up to my kitchen floor covered in water. Took it apart and discovered the pump leaks like crazy. The rubber seal isn't tight and water just pours out. And it failed Just outside of the return window so I can't get my money back.. Ran the pump under my sink to confirm how bad it leaks.