KICAAO 15.7in White Modern Wall Sconce 2-Pack,16W Indoor Vanity Light Up and Down LED Vanity Light for Bathroom Wall Lighting Fixtures Not Dimmable Not Plug (White Light 5000K)

Very bright

Thin/slim light but very bright and modern looking. I love it

I bought several of these to replace some old dated one, and they’re just great they’ve blended in with the wall which is exactly what I wanted it, plus I put out a bright light

Used them for a closet where space was at a premium. Nice and bright. Flat to the wall.

Work great

Your would think with 16W of LED light, you'd get a nice illumination of the hallway and stairwell, but it's too low key for that.

Lots of light great looking at an affordable price. Met my expectations and fit my space.

Nice bright light

I was looking for a slim, contemporary, yet affordable sconce to mount above our bathroom mirrors, and these fit the bill. I am satisfied with the design and the pleasant indirect lighting that's both soft and bright. They were also easy and straightforward to mount. Some minor criticism: the wires are a bit on the short side, making it a bit of a challenge, but definitely nothing insurmountable. Also, it took me a day or two to realize that on one of them the light does not entirely extinguish; it stays on by a very tiny margin, almost like a night light but even less than that. Other than that it works fine just like the other, and I'm not worried about it. Recommended for its elegantly simple design, ease of mounting and pleasant lighting.

Needed simply wall sconces for one of my rentals to replace some old and ugly wall lamps. Got 2 under $40 with taxes, and they look great. They are very easy to install. There is a mounting ring to install with 2 screws onto the electric device box, and then one screw top and one on bottom. The only part of the installation I really didn't like was the pre-stripped 18 gauge (thing) wires only are stripped 1/4" of an inch. Way to short to marrette with existing 14 gauge wires and quite thin. Difficult to strip a little extra for better contact, but not impossible. The wires were so thin they cut off easily with my stripper, otherwise they are great once installed.

This is a good light, but the brightness cannot be adjusted.”

Probably one of the worst designs I could think of. Why would you mount the LED driver so that it interferes with the wiring coming from the wall? The wall plate must be oriented exactly as it determines the orientation of the fixture, and it must be exactly flush to the wall, or the fixture will not be flush. No wiggle room at all. Also, the photo shows a dimmer glow on the surface (not dark like the wall), but the surface is opaque and no light comes through it.

Really bright light great for lighting up dark spaces.