Knife Pocket Clips, Deep Carry Clip Fit for most Benchmade Knives

This was a perfect fit for both my Mini Osborn and my regular size Griptillian. Strong enough to stay clipped in place without getting stuck on passing objects, plus it puts both knives deeper into the pocket where they're not as obvious. The tension is high enough it grips thin pocket material well but is still easy to slip over a denim or canvas pocket too.

Great replacement clip.

It holds on a little too tight while on my Griptilian, but I expect that to loosen over time. Significantly smaller and deeper, shows a lot less, and I hope to cerakote one of them tan/khaki at some point to improve that further Screws were a little too short for the Griptilian, as the threads don’t start until a few mm in, so I just used the screws from the included clip. Didn’t think about the fact that I use the clip to get a better grip with three fingers while opening and closing, and this reduces that down to two, just a little trade off.

Replaced the clips on my Nitecore EDC 27 & 23. Now, both carry at the pocket line and nothing sticks out. Wonderful! Just need to get used to it, as it isn't as easy to just pull the flashlight out of my pocket. The clip is shorter than the OEM clips. The side where you slip them into your pocket isn't as flared-out as the OEM clips so it takes a little more effort to get the flashlight into your pocket. The clips are very strong and really hold the lights in your pocket really well.

Perfect for nitecore lights

Order this product because it said it would works with my benchmade mini griptilian. Clip lines up and all but the screws that this kit comes with are to small. Wish this kit came with a variant sizes of screws for the different knives it shows on the description that it works with.

Pictured is the actual Benchmade clip (top) and this clip (bottom). The lack of depth causes it to eat your pocket up as there is zero bend whatsoever. Is it a functional clip? Yes. Is it as good as the actual Benchmade clip? Absolutely not. Plus the screws it comes with DO NOT fit Benchmade knives. Use this information as you wish, just know you get what you pay for.

I have bought a few different ones in the past and all have bent. This cheep clip is still holding good

This is the same clip design that comes on the benchmade bailout. I installed this clip on to my benchmade freek as I hated how much it stuck out from my pocket when being carried as I am used to Ultra Deep carry clips from prior knives. Recently purchased a couple Benchmades as I was looking to upgrade my EDC gear to stuff that really gives me the "FIZZ" If you know you know :). This made me from not wanting to carry my freek to now Carrying it with ease. You wouldn't notice how much the Deep carry clip makes a difference till you don't have one as I keep my knife / cell phone in my front pocket and without the deep carry I found my phone was hard to get out sometimes. No long-term review at this time however I imagine it will last a good while provided I do not catch it on something broken many knife clips like that in the past, unfortunately. Will update review if long term opinion changes if I remember of course :)