Titebond 4 Oz. PVC Trim Joint Adhesive

Thick, gap filling, shock resistant, great for model kits and minis. You get a lot of it too! This stuff is great. One thing to be aware of is the 'thickener' can separate or some of the thinner super glue come to the top, making it suddenly act like super thin glue. Give it a couple of good shakes before using.

Very thick- not good for small, thin grain delamination on real wood. Does the job on bulky polymer decking. Must use with activator for quick set.

Works as advertised. Open time was quick, be prepared with however you are going to secure the joint. I used the glue on a tan composite decking and saw some discoloration where I had to wipe squeeze-out. It worked. The miters are solid without fasteners.

This stuff sticks! We have a vinyl pergola and needed something to keep the plastic tabs for our string lights intact. Well, this Titebond did the job. It's not cheap, but definitely worth the price for peace of mind to know that our party lights will stay in place, regardless of the weather. I highly recommend!

Glues are in that "believe it when see it" category. Nothing I say should convince you otherwise. However, This isn't just for PVC I use it for nailess woodwork and I'm happy with it. You can buy the activator spray if your not happy with the already fast 30 sec. set time. Tried to pull 2x4s apart after I face glued them and only crowbar and hammer would do it and even then it held. The wood just splintered! Crazy stuff. Dont buy large bottles though if not used up in under 60days it will begin to crystallize and get a little chunky on the surface.

Pleased with product - exactly as advertised. A little on the expensive side. Might look at alternatives.

This glue works extremely well for glueing PVC 45 degree joints for deck picture frame installation. I also used it to splice / glue in an edge piece where my router kicked out of a groove cut.

Wow! This stuff is great. It is thicker than traditional CA glue so there is some gap filling ability. Make sure all of your joints are prepared properly. I applied the glue to both surfaces which gave me some additional working time. I clamped the pieces where I could otherwise holding in place for 60 seconds does the trick. Don’t muck with the pieces once in place, let them dry completely. Product will dry in the bottle once exposed to air so use it while you have it. Not recommended for long term storage once opened.