Spicer 5-760X U-Joint Kit 1310WJ Series (ISR)

Spicer is the only brand that I would trust on my Jeep axles. Quality is the best, and the price is right.

Did a ball joint job on my Dana 30 and took the time to replace out the U joints on my front axle shafts. Pretty straight forward once you have done it once. They are upgraded rubicon u joints designed for jeep and fit perfectly my jeep TJ.

Good quality U joint. I installed on my TJ Rubicon front right axel shaft, the old one was not doing so good. It's been a few years in use and it has withstood the abuse from the trails and and miles on road. Still feels solid.

Front axle u joint failed after 19 years. Jeep Wrangker uses Spicer, so I went with this again. Repair went as expected & axle functions fine once again. Box states made in USA, so quality, design & performance are top notch. Would highly recommend this product.

This fit my 98 XJ with the Dana 30. They’re the Spicer U-Joints so there’s nothing bad to say! (I don’t know if their quality has gone down since the XJ’s were made or not but regardless I chose something decent because I DO NOT wanna do this job again lol) I recommend that you DO NOT install with a press (install with a ball peen hammer if you have one) and install with only one of the two corresponding caps on if that makes sense. I tried it with a press and crushed the seals AND the joint pushed needle out of place so I have to buy a new u-joint for the other side, still cheaper than if I paid a mechanic and now I know something! This is not an exhaustive install guide and there are tips I haven’t mentioned but remember to beat them with your hammer to seat the joints in place so that they move more freely. For what it’s worth the wheel hub stud part (removable from the shaft) had slightly more resistance — that may be an install error but it’s a note in case anyone else was curious so if I installed correctly there is supposed to be slightly more resistance where I mentioned.

Unfortunately did not meet my expectations for spicer. Ordered two, one was missing a seal, the other showed up with the bearing cap already off and a little bit of rust inside that bearing cap. Assuming I got duds but still disappointed.

I had to purchase this unit to replace a bad U-joint that came installed on an axle from Dorman that I purchased on Amazon to take care of a previous U joint issue that occurred in my 2000 Jeep Cherokee. I had to buy the Dorman axle becausea the previous U joints that were installed on the passenger side the cap became unable to repack because I drove a little bit too long when I first started hearing a noise. The cap have been banging around in the assembly and was no longer able to be repacked but unfortunately the Dorman U-joint was garbage and Amazon,since it was still in the warranty period, let me receive a U joint instead of the entire axle (what a great company) so not only did I save them money the operator suggested I get a great one and this was my pick. Great item, easy enough to install... You will not be disappointed!

Strong and fits well

Encaja bien con jeep Wrangler 2 puertas 2008 X

Have had really good luck with these joints on my Jeep which sees a higher than normal use offroad. I usually shop around when buying them as the price seems to fluctuate a lot. The last few times Amazon has had them cheapest. The last one I had go was only because I pinched one of the seals during an install and it still lasted 75000km before I spotted it during an inspection! Of my order I ordered 2, however one was missing the set of C clips, this is ok as I'm only ordering them as spares and so far the exchange process seems like it will be simple.

Solo comparando el viejo con este se ve una gran diferencia, lo encontré a muy buen precio aquí. Yo trabajé en Spicer donde se hacen estás crucetas y estoy seguro que son de la mejor calidad.

es lo que necesitaba

Considered best replacement