CZS Sheet Metal Cutter Drill Attachment, Electric Drill Shears Attachment Cutter Nibbler, Metal Nibbler Drill Attachment for Cutting Iron, White Sheet, Steel, Copper, Aluminum

This thing works amazing. I attached it to my drill in just a few minutes with no hassle, and it started cutting through sheet metal way easier than I expected. It’s smooth, pretty precise, and doesn’t feel cheap at all. Definitely a great little tool to have and it’s cheap 👍

If you want to purchase an item that has unclear directions that are numbered to assemble this would be it. Not only does the photo not show other pieces that have to be assembled. They are not in one-size-fits-all. As you can see the earring fell out of the main housing while I was using it. The metal that I was cutting within specifications as to what it could handle. Then the tire piece came out out of the main housing that drives the gears for the cutters. It did nothing but ruined a piece of metal that I was trying to cut. The spring that they do not show in the picture that you have to figure out how to put on shot off during the attempted use. There is also a stabilizer bar that goes from the top of the drill down to the base of your drill, but while you’re holding your drill, the end of the stabilizer bar digs into your palm. I do not recommend this product and have so little faith I am not returning it to get a like one. Requesting the refund this time

This device is amazing. Cuts through tin sheets wonderful. Highly recommend

hard to attach. may not fit everyone's drill. I was able to attached to a battery operated Porter Cable drill. This cutter does a great job on flat metal and cuts through roof panels with some effort. I used it for about 2 hours, I had to adjust the screw one time. the instructions are terrible.

Was skeptical about this with the reviews...but...bought it anyway. I think I see and understand the negative reviews and have some things to add to help clarify. 1st. I used this on metal...22g and it cuts it just fine...the reason I bought it was to cut squares of flooring to use as pads/silencer pads to quiet the steel weights in my test weight carts. I had pictures of me cutting the steel sheets and the flooring (vct or whatever they call that stuff) but can not find the pics this is all i could find. 2nd. The flat outer non knurled wheel is adjustable...it need to be run in and have the same pressure against the other wheel as a pair of tin snips/hedge trimmer blades have against each other. Too loose and you will get the cuts like you see in the pictures posted....too tight and it will bind up and not cut well. 3. Add a bit of oil to the blades to help the disks slide over on another.. remember you are tightening them to one another. 4. Use a variable speed drill on a very very slow speed....the slower I went the better/smoother/straighter my cut was. Don't use an impact driver... 5. Get the angle right on the drill and duct tape a paint stir stick to the back of it to let the stick ride on the metal and it hold your drill at the right angle to you can concentrate on steering and pushing. Plan your direction of cut...this tool operates the same way red and green snips do.....IT IS DIRECTIONAL WITH THE UP AND DOWN PUSH! Do those things and this little tool is a great little cutter. Don't think for a second you are going to use it for a construction tool or industrial use or even to cut all the panels on your new barn roof. But for the occasional cutting and light use this is a good little tool. For 20 bucks don't thing you are going to replace your kettle shears or nibbles or even your red and green wiss snips.

this item is ok for flat pieces but will not work on uneven items like roofing

Got the job done. Was nice to not have sparks flying in the wind as I was cutting outside. Takes a little practice to get the pressure right to cut straight. Make sure it’s nice and secure .

Total waste of time and money. It was going to cost me to return it so I kept it. Would not waste my $$ on this. It does not cut well. Get a grinder blade