Tail Lights Assembly Replacement for 1979-2006 Wrangler TJ YJ CJ5 CJ7 Red Square Rear Combination Tail Lamps with Passenger and Driver Side Marker Stop Turn Signal Brake Lights DOT Certified, 2Pcs

Easy installation nice and bright compared to OME. Case dose not have metal backing other back of the light. So you need to be car careful not to over tighten. Also you will need to put a rubber spacer better light and the body of the jeep.keep it snug.Other then that good product .

Easy to install and look great! Love that the lens in smooth so mud isn't trapped in the grooves like the original lens.

Works fine and they’re nice and bright. I had to drill out the mounting holes a little larger to get them to line up properly, but no big deal. Otherwise they fit fine.

These tail lights look great and are very bright! They seem to be of decent quality, but time will tell in this punishing Florida sunlight and rainstorms. Installation of the light assembly to the Jeep was simple enough, and it seems to be an exact fit for the mounting screws....but the wiring instructions and diagram proved to be a royal pain. Make sure you have a solid understanding of what wires on your harness control each function on the light before you remove the old tail lights. The only other suggestion I'd make is that you also buy a 2-Pin Flasher Relay WITH a Ground Wire to replace the stock relay in your fuse panel under the dashboard. It is super cheap and automatically reads your voltage to the LED's, whether or not you still have the incandescent front signal bulbs. This is the only way it can be compatible with the turn signal functionality. It'd honestly be worth the extra money if the supplier sold these as a full kit!

Used on my 1984 CJ7. They worked perfectly, had to drill out one hole bigger to line up. The white ground I just put on one of my bolts that hold the light on. Factory plug is white male is running lights, green is turn and white female is reverse.

Put on my 2002 Jeep Wrangler. Fit great and are very bright, they do need to be wired in not just plug and play but very easy to wire and are good quality.

I was prepared for the questionable quality for what the price was and I was correct. The plastic is thin and the holes for the bolts don't line up. Be careful with removing the LED assembly on the drivers side because you have to remove it to get the bolts in. I used a drill bit to widen out the holes so they would line up.

The fit was perfect, and they work just like originals on my 87 Jeep Wrangler

perhaps as my 97TJ is the 'export' model. the taillight wiring on my TJ has the Stop and Turn Signals on sperate wires (and original light has separate stop and indicator bulbs) - but this led light does not - these are not fit for purpose in NZ since the indicators would not flash whenever the brake light is active. otherwise these look good

Greats products light are very bright the only thing I had to do was make a new hole to fit the existing hole on the body for my jeep TJ Everything work very well

Muy buen producto. Lo volvería a comprar.

very good qualiy

Great value. They work flawlessly