Hi-Roller Spa Cover Slider Shelf - Dual Retractable Lifter Arms

These cover slides are high-quality and really tough and strong. Very easy to install. They work as well as as they say highly recommend them.

Been using this system for six months and has worked well as advertised. Easy to slide lid off and on for daily use. Holds the lid well while hot tubbing. Easy to slide the lid back on after use. Would recommend to others. The plastic hardware for the frame is OK but not super strong so is vulnerable to blows taken from the side, and should be protected. I could easily see young kids who don't know better, weakening or breaking the support arms. It has been a great solution for our house!

Definitely a back saver! Works well. Feels a little flimsy but has held up

I really like the flexibility of this cover “lift”. You can set the screws into your spa cabinet as high or low as you like, which means you can recess the cover some to improve the view you have while using the spa. We didn’t want to look at two feet of the cover when we’re in it, as we have a private, treed back yard. It was simple to install and our large cover (94” square) seems to be held up just fine with the two arms provided. If you have a heavy cover, maybe consider buying another set for added peace of mind (for the money, you’d spend far less on two of these compared to other lifts). We leave our arms up most of the time too, because we have plants on that side of the spa and we didn’t want to traipse through the garden a lot.

After considering many different cover handlers, I settled on this because it's very simple and gets the job done. To be super sturdy, I installed extra bracing (just a couple of 2x4s screwed into the frame, behind the spa side panel) for "The Slider" mounting screws to go into, so they're not attached to just the panel itself. "The Slider" is of heavy duty plastic construction, and I expect it to last as long as the spa itself.

Opted not to install on spa panel wall due to it might crack or break way from panel. So I went this route with 4x4 base post brackets and 4x4 redwood con common. Extra cost roughly totaled around $50.00 but well worth it.

My spa is too small for the regular cover lift. It also doesn't have flat sides so hard to drill and place anything flat on the sides. This is a great product to create a custom made solution. Like some other reviews, I built my own stand to have this roller attachment and it works great.

The brackets are OK. Good construction, heavy enough to hold my cover. DO NOT BLINDLY FOLLOW THE INSTRUCTIONS. If I would have, it would have ruined my rear panel. The problem with the instructions is that they assume you have wooden panels. They ask you to measure the exterior facing and screw the brackets to the wood. But I have plastic exterior panels. If I had done that, I would have drilled through my panels into spray foam. Instead, I removed the plastic panel to find the tub's wooden structural supports. That is where I mounted mine...otherwise, they would not have held. The second issue was the length of the mounting screws. They were not long enough to go through the brackets, the plastic panel and into the wood supports behind them.