Talon - Snappit - Anthracite Grey Pipe Cover - Pipe Cover with Measurements 20 x 1.8 x 11 Centimetres - Mess-Free - Cover Copper Pipe - UV Stabilized - Made with UPVC

Hard plastic snap on grey coloured cover for your copper 15mm pipes and a soft plastic disc cover to hide the hole in the floor where the pipes come out. Snap on very easy to trim to length (I used a junior hacksaw) and fit, if your pipes are vertical and true. There is a small gap between the edges which needs to be manoeuvered to the rear to stop being visible. Cover for hole very flexible and fiddly to locate the click fastening. However, once joined gives a good fit. Be aware that your pipes need enough clearance to the wall or skirting for the diameter of the disc, otherwise you will need some nifty surgery with a Stanley knife. Anthracite grey is the perfect colour match for our vinyl flooring. You could use the pipe covers with a carpetted floor, but I think the discs are only for vinyl or laminate flooring. A well made product that looks good when in situ.

These pipe covers are really good quality and good value for money. Very easy to install. Just cut to size and no hassle at all. Highly recommended

Tricky to cut. The pipe covers are very thick and sturdy, this means you'll need a hacksaw to cut them to size. Also pay attention to the width of the base cover. I measured 25mm from the edge of the pipe to the outside of the base. If you have thicker skirting or pipes closer to the wall the base won't fit between skirting & pipe. On one side of the radiator where I fit this cover I had to file the back edge away slightly for it to fit. Once in place they do look very neat. Especially useful for covering laminate floor pipe notches if you maybe didn't do the most tidy job with your jigsaw :).

Easy to install and does the job of covering unsightly pipes

Nice product, easy to use, easy to cut and look good.

Not easy to cut to length really but worth persisting.

They fit the anthracite towel rail heater nicely. Pipes can be resized with a hacksaw, and you obviously make the slits at the back face the wall for a neater look.

I have three vertical radiators in anthracite grey in an extension to my home. The contractor finished reasonably neatly around the pipes, but not perfect, so I wanted something that would make them neater. They are easy to fit, even though the pipes were closer to the skirting than the radius of the collar. All I did was measure the gap and cut across part of the round collar (make sure you don't cut where the joint is). It then fitted neatly around the base, and I cut the length of the pipe cover to suit the gap. All looks very neat. The only thing I would say is that they could be a few pounds cheaper, as they are just moulded plastic.

Sehr einfach anzubringen, die passende Größe ist leicht mit einer kleinen Säge herzustellen. Ich habe testhalber einige der Snappits zuerst in gut warmes Wasser gelegt u. ich denke, damit rutschen diese noch leichter über die Heizungsrohre.

Kann ich definitiv bestätigen: Die dreifache Maßangabe:"Geeignet für 15 mm, 22 mm und 28 mm Rohr " ist irreführend. Es ist definitiv nur für 15 mm Rohre geeignet. Und zurück...

Empfehlenswert

Entsprechen der Beschreibung. Einfache Montage. Einfach zum Zuschneiden. Max. Rohrdurchmesser liegt bei 22 für die Verwendung.

Die dreifache Maßangabe:"Geeignet für 15 mm, 22 mm und 28 mm Rohr " ist irreführend. Es ist definitiv nur für 15 mm Rohre geeignet.