Peel and Stick Baseboard Trim,2.1 Inch x 20 Feet Rubber Wall Base Moulding Trim,White Cove Base Vinyl Baseboard (White)

Used the Cove Base where the Bathtub front meets the floor. Covered the gaps, nice and shiny. Most importantly stuck to the metal tub. With other bases, the adhesive would fail and I would have to use other adhesives to make them adhere.

I am satisfied. Finish my basement renovation.

Great product!

Works well, but could be a little bit stickier. It unglued itself where some silicone was present.

I’ve been needing to replace our tub cove moulding for a couple of years now, but could not locate one that was around 2.5” high and had a nice little kickout slope at the bottom to cover the small gap between the tub face and the tile. I finally found this one and it worked perfectly. It’s very supple and easy to cut with scissors. The adhesive on the back is extremely sticky and adhered to the tub surface without any issues. Once you peel off the backing, be careful with placing it. You’ll be able to shift it only a tiny bit once it’s in place. I started at one end and left the backing in place halfway along the section I needed. I slid the first end into the gap I made in the baseboard that butts up against the tub and aligned the vinyl moulding where I wanted it. Then slowly worked my way towards the other end, adjusting the height as I went and gently pressed it against the tub. Once I had the entire strip mounted, I was able to go back and fine tune it a smidge. Lastly, I used the backing (which is super slick) to rub back and forth a bunch of times to make sure the adhesive was secure. It’s bright white, just like our tub and appears like it will last another 15 years (which is how old the original junky moulding was). For the price at 20’ of product, you can’t go wrong, and will have enough extra if you mess up and cut it too short. To finish the edges off, I recaulked the corners and it looks amazing.