DaierTek 12V Relay Box 6 Way12 AWG Pre-Wired Waterproof Relay Box 6 Slot ATC/ATO Fuse Relay Block Universal Relay Panel for Automotive Car Marine Boat

Works amazing. Used it to wire up lights and a few other accessories. Surprisingly very good quality. Waterproof both top and bottom. Top and bottom panels come off to switch the wires around if needed. True gauge wire, kinda stiff and it seems to be real copper. All the connectors are brass. Relays work and show the diagram on top. Instructions were very clear and fit in the lid for future reference.

Absolutely amazing, I wish the supplied wires were a little bit longer but no more burning out switches for me. Insanely simple to wire and very satisfying hearing the relays click.

I needed a better way to wire the lighting on my Ford F150. This item was great! It has 6 connections. Very easy to wire. The relays work great just hit the switch and the lights jump on very bright! This fit right behind the battery and tie in was very easy. 1 ground wire and 1 battery line and your set. Just use your switches. I found that this was the best value by not having to buy each item separately. this comes in one easy package.

High quality, works as it should, easy to install.

The box works.........however, tails could have been a bit longer, in no way is this thing water resistant, or dust resistant, so make sure it is mounted in a non-weather exposed spot, preferably inside the car. I mounted my under the hood and after one rain storm it was wet inside. This is not a mystery as there are no seals what so ever on the wire loom or lid. If water is present, it's getting in. Also, the fuses were pretty much junk and all needed to be replaced. Have not had a problem with the relays yet. Sum up: it's a cheap & quick way to add a few relays, but will most likely fail from heat, moisture or dirt intrusion if mounted under the hood.

Good for my JEEP electrical accessories. Controls loads placed on the JEEP’s electrical system.

Everything works the relays are switched positive and the gray wire goes to ground.

Seems pretty well built, but definitely NOT waterproof. Sending back.

This item almost perfectly met my requirements. Great instructions & easy to fit. It has cleaned up my wiring & grouped all my fuses & relays in one spot. The only negative is that it’s a bit hard to remove the relays as they are quite close together. I would recommend this product.

Worked great. I used a battery terminal fuse and just wired it right to it so we didn’t have to install a bus bar and separate wire with fuse etc. Seems reliable and quality 12ga wire for lots of power to aftermarket heated seats and a rear truck cap defroster. Handles the amps well.

Used this for a 2jz engine swap to run coils, injectors, ecu, pwm fan controller, etc all on their own relays. Small and clean install. Very happy with the simplicity. Be sure to double check fuse sizes of the relay to what the load draws. They come pre installed.

Works great

Parfait pour petit projet mais dans mon cas (swap LS) elle n'est pas filé comme j'ai besoin mais c'était mon risque. Manque une étoile pour le manque de joint d'étanchéité et fil positif très court ce qui complique un peu l'installation.