HandAll Beavertail Rubber Grip Sleeve for Glock 26, 27, 29, 33, 39 (Gen 3 & 4)

GREAT GRIP...CAN TELL THE DIFFERENCE AND HELPS KEEP THE FIREARM SECURE IN YOUR HAND WHILE FIRING...nice recoil absorption and get your sights back on target! ONE PIECE OF ADVICE ON INSTALLING....I BOILED WATER TO BETWEEN 80 TO 100 DEGREES POURED IT INTO A LARGE BEER MUG AND SOAKED THIS THING IN THE WATER FOR ABOUT 3 MINUTES...THEN TOOK IT OUT WITH A PAIR OF TONGS SPRAYED THE INSIDE WITH WINDEX AND SLID IT ON THE HANDLE...NOW IT'S TIGHT, SO ONCE YOU SLOWLY GET THE EDGES ALL AROUND THE BASE AND START NUDGING IT UPWARD, THE RUBBER SHOULD BE NICE AND WORKABLE TO WHERE YOU CAN SLIDE IT UP, ONE SIDE AFTER THE OTHER, UNTIL YOU GET IT IN PLACE, ROTATE IT A LITTLE (MAYBE) UNTIL IT'S JUST RIGHT. IF YOU SOAK IT ENOUGH YOU DON'T NEED PLIERS. I BOUGHT THREE OF THESE ONE FOR EACH PISTOL AND FOR THE FIRST ONE I USED PLIERS ON MY G27 WITHOUT WATER, WARMING, OR WINDEX AND THE PLIERS RIPPED THE RUBBER ALL UP...SO NOW I HAVE TO BUY ANOTHER ONE FOR MY G27 AND TRY AGAIN AFTER I STARTED TO GET THE HANG OF THIS AND GET MY RHYTHM GOING - FOR MY OTHER TWO (G23 AND G19) I WAS ABLE TO SLIDE ON FAIRLY EASILY ONCE I GOT THAT SYSTEM IN PLACE! READ THE REVIEWS OF THOSE WHO DID THIS BEFORE ME...TRUST ME, IT WORKS! GOOD LUCK! AGAIN GREAT GRIP!

Perfect fit for G27 Gen3. Can be difficult to install but I heated it up with hot water and used a little bit of dish soap to slide over grip of frame. I've used other Hogue grips but required trimming. Not this item; it an exact, clean fit. A quality product.

Took forever to work on, but works great!

The over grip is well made and fits my Gen 5 Glock 26 perfectly. The grip makes it easier to grip the pistol (I am a man with average size hands) and it helps a lot to absorb recoil. The over grip makes the pistol more comfortable to shoot and more comfortable against your body in a holster. It fits snugly on the original Glock polymer grip. To install the over grip, I warmed it up in hot water and also wetted the pistol grip with hot water. The hot water allowed just enough stretch to slowly slip on the over grip. I would highly recommend this product. The recoil absorption would probably be even more beneficial for a Glock 27 with the snappier .40 caliber.

Very tough to get on but great when you do, put them in very hot water for a few minutes to soften them up, or use a hair dryer.

Don't be concerned..I read the reviews and was concerned about it fitting.. expected a struggle...don't pay attention to their suggestions..just throw it in hot water..in the microwave..3 min..have your handle coated in dish detergent..take it out with tongs..and it literally slides on so easily..took me lees than two min to slide it on..no shoe horn..no pliers.. nothing..and soon as it cools..it's great..doesn't move... This thing slipped on like my shoes....

Fits perfectly on the Canik Mete MC9.

Great fit but the cost for shipping was to much. Try and use a different supplier