Wilson 305-830 18-Foot Belden Coax Cable with PL-259/FME Connectors - 18FT

The cable is well designed and built of good materials. The removable PL-259 made the installation a breeze. The only issue I had was a poor solder connection on the PL-259 center conductor. There was solder on the outside of the weather boot end Pl-259 center pin. It wouold have been a poor fit and not what I expected from a higher quality cable. It was easy to carefully remove the excess solder with a very fine file. I was unable to find a way to notify the supplier that they need to check stock and address it with Wilson. Hopefully they will see this post. Delivery was excellent by the way. Best Service Stores delivered fast. In their defense there is no way they would have noticed the solder issue. I consider them a top notch vendor for price and delivery. I just wish I could notify them without going thru Amazons filters and categories. None of the selections were "helpful feedback" from a happy customer. All the other choices would not have been fair so all I have is this post.......... UPDATED 11/14/15 - Important install note: The cable survived the sun, mud rain and snow for over 2 years but then failed due to my install method. Use caution if your antenna is on the door and you need a cable that will flex with the hinge action. I ran my coax thru the factory gate wire chase which holds it to a very limited space. It eventually broke in half with the constant opening and closing of the gate. This is a very well made cable but bear in mind the specs and construction of a high freq coax is not the same as every other 12V auto wire. I am happy with the cable quality and replaced it with another wilson 305-830 but this time I added a large loop to limit the flexing. If i have any other trouble I will post here.

High quality

Worked perfectly

I like this cable, it's easy to install and route thanks to the small end with the adapter, only need a 1/4" hole to get it through the sheet metal. The rubber boot is a nice touch. I only have about 4" of the braided line exposed which looked pretty cool for the 1st month then it started turning yellow. I wish I had known that or I would have put some black flex sleeve on it before I routed it through the metal. Looking for a way to cover up the ugly yellow now. Performance wise, I can't complain. CB sounds great, nice low signal on the SW meter. Plenty of length to install in my 1997 Landcruiser. Antenna's mounted on the back driver's corner at the tailgate, CB above my left knee under dashboard. Great cable...except for the yellowing.

High quality cable.

Good product wored as needed

This length cable gives you enough to be able to hide the coax out of site when installing CB

Good product

Muy buena calidad

This was perfect for my jeep set up.

Installed this on my 4 door Jeep JL Sahara with a President McKinley CB radio. Having the smaller end on one side makes it a lot easier to fish the cable through the roll bar trim and to an overhead CB bar I bought from the states. Works great and the connectors are strong.

Buen cable fácil de instalar y buena calidad del producto, lo recomiendo

Facile à utiliser! Parfait pour un Jeep!