SC92108 1-1/8" Hex Shank For SC10018 Floor Scraper

The product appears to be high quality but unfortunately we received a defective product that broke in 2 hours and could have caused alot of damage if my husband was not truly a pro a notice what was happening.Bolts started flying off and then the piece broke in half.If you are using a Makita 35lb Jack Hammer do not buy this product.

Don’t even try it, very bad quality made, broke after 1 hour of use, you get for what you pay . I ask for a refund or replacement and the seller didn’t do it .The screws on this one are 3/8 of inch thick very thin .... the screws on the CHAMPION CHISEL WORKS are 3/4 inch thick ... even the iron around the plate is much thicker and bigger than this brand for $80.So If you want something good and very well made, buy CHAMPION CHISEL WORKS. It cost $300 but won’t brake . This is what I bough now and is amazing.

Used for like 20 mins spade bent waste of money just bite the bullet and buy the more expensive one

Bolts loosen over time as mentioned by other reviewers, keep an eye on it and retighten. That’s the only complaint I have, easy grout removal beyond that.

Just what I needed, too bad end of shank did not fit my jackhammer. Had to modify it a bit

I bought this piece and it broke. I was wondering if I could get another sent to me free.

Appears to be a good product but does not work with the harbor freight demo hammer. The shaft is approx 1/8” too short.

It does the work. The nut bolts constantly get loose do to vibration effect