Pyle 6.5" Three-Way Sound Speaker System-180 W RMS/360W Power Handling w/4 Ohm Impedance and 3/4'' Piezo Tweeter for Car Component Stereo,Round Shaped Pro Full Range Triaxial Loud Audio -PL63BL,Blue

Thes work wonderful for the stock car system Great sound Easy installation

These are the second pair of these I've bought. The first ones lasted about 4 years being played at super high volume the entire time. For the price you cant beat them as far as sound quality ande loudness, although they do need an amp to get a good sound. The new ones sound great as the first ones. If you want decent priced quality speakers , then I recommend these for sure.

Installed in my 06, Chevy truck. Replaced blown speakers. Sound decent. Only 4 stars, because the box card says 5 year warranty, but they only give you 3.

Great little speakers! Used it on a Bluetooth cooler project and it worked great for my application. Also a great price, great fit and super easy to hook up.

I bought the Pyle PL53BL speakers to replace the factory rear seat side panel speakers in my 97 Dodge 2500 Club Cab. I bought these before removing the original speakers, as all the speaker fitment guides here and elsewhere indicated these were a fit. They did fit but weren't an exact fit as the original speakers were closer to a 5.75" or possibly 6" size. The two speaker mounting points in the truck's metal were spaced just close enough to enable me to get mounting screws in the slots in the Pyle speaker frames, so they did mount OK. However, due to the smaller diameter there was a sizable air gap (about 1.8" or so) between the speaker and hole in the truck's metal. I closed off this gap using some putty-like weather rope seal from a big box home improvement store. I'm running these speakers on an older Alpine CDA-9856 head unit and Alpine 3566 6-channel amp (conservatively rated 35W RMS x4 and 120W RMS for bridged sub channel into 4 Ohms). Following advice from several reviewers and professional installers, I bought a roll of sound dampening material to apply to the door panels and elsewhere. I bought roof repair material - Tape and Seal is one brand - which is very similar to another very high priced product and it worked quite well. Once this was done and the speakers were mounted and connected to the amp, I turned it on for the first time. After the initial checkup to make sure all speakers were working, I cranked up the volume to a pleasantly loud level and was very surprised and pleased to hear the quality of sound coming from these inexpensive speakers. Being 5.25" bass drivers they understandably don't produce much bass output but the midrange and highs are much smoother and detailed than I was expecting. I paired these up with a pair of Pyle Driver PLDV6K 6.5" 2-way component speakers in the front doors and I'm very pleased with how nicely these compliment them. They're well matched regarding their efficiency, producing very near the same volume level and similar sound quality. While not quite as smooth and clear as the fronts, they do a splendid job of providing clean sounding music to fill the rear seat area and filling the back of the cab. They're SO much better than the original factory speakers. So, long story short, I HIGHLY recommend these for anyone looking for a very reasonably priced, smaller coax system and wants surprisingly accurate, smooth and detailed sound quality and listens to their music at reasonably loud levels. I would definitely buy these again and recommend these to others. UPDATE: After about 2 years these speakers have basically "given up the ghost" and for the most part are now inoperable. I had hoped they would be able to handle the clean power of my Alpine amp, especially since they weren't getting all the bass signal they would in a full range system, but alas they didn't. They are now working intermittently, with audio "popping on and off" as the speakers' litz wire (the flexible wire between the frame and cone) apparently makes and breaks continuity. I still liked the sound quality they produced when they worked well earlier, I'm just now believing they aren't made to handle even the 35+ watts RMS/channel my amp can produce. The front Pyle Driver PLDV6K 6.5" 2-way component speakers on the other hand are still performing well, which is why I believe it's just a simple matter of inadequate power handling ability that has caused these speakers to die off. In a lesser powered system they may work better and longer.

Fair sound quality for the price with generous accessories. Used for a cooler radio that I built and haven’t had any issues. They do tend to get a bit distorted at higher volumes but that’s somewhat expected given the size. The included screens and cable were generous, as were the templates for cutting. No complaints.

Please bear in mind that these are INEXPENSIVE speakers. (If I had paid $50 or more per speaker, I'd give 4 stars. $100 or more would be 3-4 stars) I put myself through college installing high end vehicle stereo equipment, so I feel that I understand a bit about car audio. My assessment: Excellent value, solid quality of sound, simple installation. I was able to remove the door panels, clip wires from stock Infinity speakers, clip-bind/fuse & cover wiring that came with the speakers, test sound, and replace door panels...all in 35 minutes. I recently gave an overhaul to my 1994, solid as a rock 318-v8, Dodge Dakota SLT Ext cab. My father bought it new in '94 & I bought it from him rather than have him sell it. The original factory speakers were all blown, save the right rear 5x7. I don't listen to deafening levels of music...I just like to enjoy a full range of sound from my music. I was shocked by the quality of sound for the price. I got these for under $15 from Warehouse Deals. I fully expected to get sound that was on the low end of "acceptable" for the 45 minute boat haul sessions to & from the lake, or the quick little in-town trips. Needless to say, I was pleasantly surprised. I cranked everything from 2Pac to Evanescence in testing the speakers. At full volume, since the factory stereo only distributes roughly 15 watts Continuous Power("RMS") per 4 channels, and these speakers are rated at 100 watt continuous/200 watt max, there will be some impedance on the highest volume output delivered from the receiver. If you're using a factory receiver, on any aged vehicle, and want to be an idiot who hopes to go deaf some day...you may want to add a dedicated 2-channel amp with 50 watt output per channel. These little speakers will sufficiently handle you mid to high-range needs. I HIGHLY Recommend these speakers to anyone who likes a full range of sound, without the bloody eardrums. The sound quality WELL EXCEEDS the price you will pay.

Fonctionne très bien

Suoni puliti e definiti, molto meglio dei diffusori originali (anche loro di ottimo livello).

Great value for money. Fantastic sound . Easy to fit . Very strong speakers . No distortion.

Super Preis-Leistung! Sehr guter Klang!

These car speakers performed well above my expectations, especially given their affordable price. The sound quality is exceptional — with crisp highs, solid bass, and a clear, well-balanced overall output. What impressed me most is how powerful they are for their compact size. They easily outperform some higher-end brands I have used in the past. Installation was quick and straightforward. For the price, you truly can’t go wrong. Highly recommended!