Wellgo 608-2RS Ball Bearings Skateboard Bearings Double Rubber Sealed Shielded Miniature Deep Groove Bearings 8mm x 22mm x7mm for Skateboards Inline Skate Scooter Roller Blade Skates etc -10pcs

Works for my needs

bought these to replace 608z bearings that came with a brand new Oregon lawn mower balancer. one bearing was ok and one bearing was faulty. bearings measure 8 mm bore, 22 mm outside dia. and 7 mm bearing housing width. bearings fit spindle and housing with no issues of fitment. bearings are double sided plastic shielded and were oiled with light machine oil without removing the shield. bearings were bought for free movement and close tolerances and are better than what i replaced. bearings arrived sealed in plastic bag and placed inside a clear plastic storage tube. mfg advised not touching bearings with bare hands doing installation. very happy with fitment and performance and like the idea the side shields can be removed if necessary. a good value for 10 bearings and i now have replacements if needed in the future

Great bearings for the price. Wasn’t expecting ABEC 11 for this price!! Very smooth and no noticeable play or tolerance issues. Very well lubricated so if you want them to spin for a long time like in a fidget spinner then either wash out the heavier lube or buy other bearings. Fits perfectly on 8 mm shaft. (Shaft actually 7.98mm. Bearing ID about 8.02mm). Measured other 9 bearings and all were within 22x8x7mm +- .06 mm. While not ISO or ABEC(if you’re a skater) certified, these seem to work fine for my application, which is light duty (<50lbs) hobby use. I believe they should work fine in power tools and also for heavier applications but YMMV. very pleased

I used these for an art project. They spun smooth and true. The speed that I used was pretty slow, but these looked well built and I am sure they would function well at faster speeds. Great value.

Bearings are great, they spin freely, very little noise, and they work great.

Before ordering, measure your current bearings with a digital caliper. Can't beat the price. I tried them out today by skating about a half mile and had no issues. One thing I noticed was that when properly adjusted on the skates, the did not freely spin for more than two or three revolutions, but on the street they worked fine. For you high-speed skaters, these may not be for you but for recreational skaters like me they do the job just fine.

Decent bearing. Recommended for casual use, but for it does not compete with a Bones Red or equivalent. Rolls smooth, but slow. If ABEC 2 was a thing this bearing would be it. Replaced bearings on a friends longboard. The board is a decade old and might have 20 miles on it. Did not make sense to put 'high end' bearings in.

I purchased these bearings to replace the original ones in my dad's upright walker. The original bearings were not sealed, so they wore out very prematurely and the company wanted an enormous amount for wheels. These bearings are sealed on both sides, which will increase their longevity. The wheels were plastic so I carefully pressed out the old bearings and pressed in these bearings. The walker rolls very smooth and no noise.

These bearings are just what I needed for my project. That project was a ball bearing filament spool roller for my 3d printer. They are smooth and silent and the price was right.

Used to make filament holder for 3d printer. They work great. Highly recommend

Good value for the money but not as smooth as I would expect. Not bad

Pour un treuil pour déplacer mes batteries de bateau

I repaired my Vitamix with it. It cost me $10 instead of around $100 for new part. :-) It works great so far.