Samsung DA66-00850A Refrigerator Dispenser Lever

The only difference between this part and another more expensive part that comes up as the "correct" part for my fridge is the stainless steel cover. You can remove the cover from the broken paddle and put it on the replacement via 4 small tabs (I used a small flat-head screwdriver and needle-nose pliers). To install, you just need to remove 1 screw (underneath and to the right of the dispenser hole). Pull out and then down on the control panel. No need to unplug or remove anything else. Place the right-angled end of the spring in the hole above the one where the pin goes in, put the pin in the spring but don't put it into the hole yet. Hold everything carefully and use a butter knife (or nail file or other thin flat thing) to move the straight end of the spring into the notch on the paddle. It will be toward the actual front of the paddle and you're moving it to the back side over the top of the pin. Carefully, while still holding everything steady so your spring doesn't come out, drop that pin down into the hole and then snap the other pin in. My spring popped out the first time so I had to take the pins back out and try again, be gentle. Once you get the spring in right and the paddle secured, just snap the panel up and in, replace the screw and you're back in business.

Fit right in perfectly and has worked fine ever since.

Fit perfectly…..once we got it installed. Watched all kinds of YouTube videos. They all talked about the 2 clips on each side which ours had but we also had 3 on the top. Hubby worked and worked and couldn’t get it to budge. Finally took a crowbar and got it off. Also took a little work to get the spring in. But, hey, saved us a repair bill. Seller sent extremely fast and well packaged.

It's a real pain to get the spring in place, but once you figure it out, it works perfectly. Youtube videos were super helpful to figure out where the spring goes and how to install it.

The factory lever broke and this was a great replacement. Does not include the chrome face plate so you have to carefully remove the existing, but it is fairly easy to remove.Well worth the cost to get my ice maker up and running again.

It took awhile, but finally got it installed. Works great!

Replaces a broken one exactly.

Had a broken dispenser on our Samsung refrigerator.You have to remove the metal cover from the old one. Be careful bending the tabs. I broke one but it still holds with just 3 of them.Take the whole display-faceplate off to install. There are youtube videos to show you how.Works great and is good as new!