HitLights LED Strip Connector Kit - 2Pin 8mm Solderless Gapless Connector, 6Inch Jumper, DC Female Jack Splitter

performs as expected. a little touchy to connect sometimes, but helped me finish a project. Much easier than soldering.

Well made product.

I ordered these connectors along with a roll of strip lights, having never used either before. I have no real problem with the connectors, other than being slightly bulky, they seem to work well. And they are useful if you're using the coaxial power connectors. But in my direct-wired application, I discovered that the HitLights light strip is tougher than it looks and is fairly easy to solder to directly - I ended up using these connectors on half of my project, and didn't need them on the other half. If you're handy with a soldering iron, take this into consideration.

I had installed some LED's under a table to illuminate a glass bowl 10 years ago! from this same company. The transformer finally gave out after 10 years of NEVER OFF! Super quality, well made. The new transformers work with these new connectors. Oddly enough, the LED's which came in a movie reel roll still work flawlessly after 10 years. Thank you!

Nice product.

These connectors do NOT connect. They do not work. I will be returning them for a refund. Sheerness.... what does that even mean? Oh well I gave it a zero too. Value for money. Well, since they do not work they have zero value and are a waste of money and more importantly a waste of time to experience a product that does not do what I bought it to do. Now if have to mess around with sending it back. What a hassle! I fiddled with the connectors again. This is what I recommend. Do NOT cut the lights on the cut line which leaves equal parts of the copper connection points on both haves. Cut it to leave almost ALL of the copper to connect under the metal tabs. This gives the most area to use as a contact point. It works very well. I also tried shimming the strip to make it thicker as others suggested and sometimes got that to work. But a wrong wiggle and the lights go off. Poor connection! So I recommend cutting to the far side of the connector tabs instead of down the middle. Even with wiggles the connection is solid. I have my new string attached to the first set I ordered and have them plugged in my room. They go around the wall and out to the hall. Up over and around the washer and dryer in it’s closet area lighting our hall across from the bathroom. I turn it down as a night light so I have a faint glow to get up and use the restroom in the night. A better product would be one that comes on automatically low light And STAYS ON VIA A backup battery during a power outage. I will do a search for such lights. I give the product only three stars because you have to fiddle with it and NOT FOLLOW the directions (video) to get it to work.

These connectors make it easier to install led lights.

Quality product

The quality of wire is not good. The clips are looking good in pics but in real feels Chinese clips..

It is convenient to use, but the pins in the connector do not align with the LED strip and manual adjustment is required.