Brower 4 Door Galvanized Steel Alloy 7 Bushel Hog Feeder for Livestock with Free Acting 16 Gauge Doors for Feeding Up to 20 Grown Hogs

The product arrived slightly damaged with some rivets broke on the bottom. Still very useable and repairable. Contacted Spreetail customer service about the issues and was issued a partial refund. I appreciate the opportunity to do business with them and will continue to do so.

There were several holes that I had to drill out myself. The machined holes did not line up properly they were off by more that 3/4 of a in inch in some cases. The lid also did no fit on properly. After attaching, the lid does not close all the way since the pieces they provided are not long enough to get the lid hinge far enough above the wall. Nothing that a 8 lb rock wouldn't fix but still disappointing. All in all I have the product and I need to feed the hogs so it is going out to pasture tied down to a couple of t-posts so the pigs don't throw it around. Will be looking for other options if I need a second feeder.

1. Manufacturer drilled holes for panels do not align.2. Panels dented during shipment by FedEx.3. Box destroyed during shipment by FedEx4. Top does not close to keep water out.

So I got the package a little bit damaged and one corner was bent up a bit. All the nuts were missing but seller resolved that. Started to assemble according to instructions and nothing seemed to line up frustrated and ready to return we walked away for a day. Came back to it and partially disassembled it to line up side panel holes first. Had to use a hammer to bang things around a bit but it all came together. One of the rivets did pop out but I will just glue that back in. Putting it out right now so can’t say how it holds up quite yet. Think it will be good though!!

We had bought a Brower feeder before and bought this one based on the past purchase as that feeder was sturdy and well built.The one we just purchased is not as sturdy. None of the pre-drilled holes matched up and the feeder is not square so that the top door does not close properly.

Missing 2 of the 3 rods: Part no. 13892, 5/16"×24 1/4" Lid rod, zincShipping box was damaged slightly but did not notice missing rods until put the feeder together this morning. Definitely took longer 1 hour to assemble the 1st time. After doing one assembled feeder and if metal bent and holes line up properly, assembly should take about an hour. Also had rivet missing but will fill hole with silicone as oppose to un-assembling entire project and returning over missing rivet and degree of difficulty due to holes not lining up and some of the metal creases being off.

Built cheap. When putting together the bolt holes don’t line up. Attached the lid and needed to bend it to make if close. Would not buy another anc wouldn’t recommend the feeder to anyone.

This was a CHORE to put together. The top lod didn't sit right but we made do.