UTG 30mm/2PCs Medium Profile Airgun Rings w/Stop Pin , Black

You get far better quality than what you pay for. I bought two sets of these and paid less with shipping than a set of redfield rings with tax added. I was expecting very poor quality to be honest because of the price, but with a .22 I didn't need them to be perfect just functional. I was surprised at how well they are made and the extra screws you get are a nice bonus. I did a test by tightening them and then removing to check the scope tube for deformation. No change at all, very surprised, I've used rings that cost way more and had them deform an expensive scope. Bottom line great quality at a great price and rock solid mounting.

Like: When you tighten the screws, it is going nowhere. Screws are heavy duty. Quality rings. Dislike: Scope was a fail. These went into my spare rimfire rings.

These are very good for the price, they stay snug. One piece mounts are preferred, but sometimes can not be fitted.

This is the fourth or fifth set of these I have acquired. Using them all on higher-end air rifles to mount UTG scopes. The finish is good, the screws of better quality that you might expect, and the anodizing also better than you might expect. Best part is that they hold in place, even when used on high-powered spring-air pellet rifles, which are notorious for knocking scopes loose and tearing them apart. I have, and will, purchase this exact set of mounts again.

Got them fast. Work great

I bought these because they were cheap and I just wanted to use them to try out a scope without spending a lot of money. But I was stunned by the quality I got - I am not going to feel any desire to replace them if the scope set up works out. The machining of the rings and locations of the screw holes is excellent, the fit on a 30 mm tube is perfect, the hardware is great, and they didn't need any lapping at all.

Well-built fairly heavy aluminum scope rings that fit the .22, 11mm or 3/8 rail as it is commonly called. These are Not QR rings so each is well secured with 2 decent sized Allen head screws. Allen wrench for installation is included. No ugly machine marks or other defects noted. There is a thin piece of material on the inside of the rings so your scope does not get scratched up. These are 21mm deep so use a fair amount of real estate on the tube. A bit rough looking compared to more expensive mounts but then that is expected but a good deal for the money. Med height allows for scopes with up to 60mm lens to be mounted.

I have used this mount on springers and PCP rifles and it works just fine. The mount where it clamps onto the dovetail will flip over for the best fit on 3/8 inch or 11mm Dovetail and trial and error, testing each is what I do to find out which way is most secure.