AEG Motor Super High Torque Long Type D Hole

Okay so I'm still very new to airsoft, but I've always like disassembling this, and when I was younger I would take apart nerf guns and install new motors, so when I got an airsoft gun, I wanted to try and do the same with this. It is very easy to install. You just unscrew the bottom of the handle, DO NOT ADJUST THE BIG FLATHEAD SCREW, USE THE TWO SMALL SCREWS ON THE FRONT AND BACK OF IT, and there's two little removable cables, that just pull straight off. After you remove those, take the motor out, put the new one in, and reattach the cables. I could immediately tell the difference. The FPS is raised, but not by a lot, it still does feel like it shoots much harder though. I run mid-cap magazines on my m4, the RPS difference was amazing. I use a valken airsoft stick battery with mine. I use lancer tactical, yes their stock parts are not good, but this change honestly made it much better. You can tell the difference in torque the second you take it out of the box, the head of it is much harder to rotate, so you know you're getting your money's worth. I definitely recommend this.

The media could not be loaded. Well this really improved everything! Shoots faster and stronger! At least doubled my full auto sps! Went threw 2 stock motors in 5,000 bbs. My spring is to strong but this motor takes it like a champ! My old motors would drain my batteries and make them really hot. This motor great on my battery. Last a lot long and the battery stays cooler. Just gets a bit warm after blasting full auto compared to what used to be. Didn't even want to hold the battery after shooting. Had to let it cool first. No problem now! Worth every penny!

It looks like it's made well, it's quiet, but for my purposes with an M140 spring, it couldn't pull it without having some issues. Was definitely struggling, sounded the same as my Krytac 30K high torque motor, I thought this was going to fit the bill, but it didn't. Ended up going with an Echo1 Red motor, very capable motor. I would imagine this AOLS motor would do great with any spring under M120. Probably a great speed or all around motor.

I put it im my g&g to replace the stock motor because it couldn't pull my new spring. This motor pulls my m130 spring just fine and increases the rate of fire. I highly recommend if you need a new motor to consider this one.

Absolutely love it. Great little motor with plenty of power. Fits perfectly in my Lancer Tactical Interceptor and haven't had a single problem with it. I am currently running a 9.6V battery through it which does heat up the motor quite a bit so if you plan on using a 9.6V battery with this motor just be careful that it doesn't over heat. Otherwise very happy with this product and I would recommend it to anyone who is upgrading from a stock motor. :)

What an amazing upgrade to my Echo1 xcr-c. My first motor burned out but this one is a major upgrade to my airsoft gun. Just from looking at it through the well packaged box you can tell it is a high quality product. Easy to replace and little to no adjustments were needed to get my gun up and running.

Draws 3.5amps continually, but can spoke to nearly 8a. works quite well, but if you're using a mosfet MAKE SURE you have a good quality one with over current protection.It blew out a cheapo ASG MOSFET (they're junk MOSFET systems anyway). LIdeally this would not have an initial peak current draw that much higher than it's continual draw, but with quality electronics it should be fine.

Stout motor ! Bought this as an upgrade for my lancer tactical m4. Have cycled about 3500 rds. With it! I have a m150 spring in the gun and its able to fire with no issues @ 17rps! I might try a m170 spring! Note: My Lancer is all stock except the motor measuring 520 fps with .25g bbs! 3500 rds. and counting!