Sink Soap Dispenser Extension Tube Kit with Upgraded Check Valve, 47" Under Counter Soap Dispenser Tube for Kitchen Sink, Fit Most Soap Containers, Strong Suction, No More Tiny Bottle Daily Refills

Edit 24May2023 6 or 7 months ago I posted the review below. The company immediately got ahold of me and asked to make it right by sending new tubing. I told them it wasn't the tubing, but the check valve seemed to restrict flow too much to be useful to me. They then said they had redesigned the check valve and would I try the new one. They sent that - it took me a long time to get around to trying it out. Everything seems to work very well now! This whole setup takes only a couple minutes to install, you are sucking soap from a large refill bottle so won't need to bother with it for a long time, and when you need a new bottle it won't take but a minute to replace. This is ingenious and works so much better than having to refill the small bottle that screws on under the sink. It eliminates a real hassle of refilling the soap bottle and is well worth the money. A tip: Originally, in the configuration that didn't work well, I just had the tube stuck into the hole in the dial soap refill bottle, so there wasn't any tight seal. They include a stopper with a hole that fits that bottle, so if you put that in you can close the cap over it and get a tight seal that holds the tube in place very well. I don't think my failure to use that stopper caused the earlier problem, but it's a lot more secure installation using it. Old review: It took only a minute to install. The amount of soap coming out with a single pump was a lot less than in a standard setup, 2nd pump had almost no soap, and 3rd pretty much none. Recovery takes a bit. I thought maybe the check valve was too restrictive so tried a different one and it was worse. Using dial soap and it may be too viscous for this setup. I finally just went back to the factory setup.

I have an Allen + Roth faucet from Lowe’s , item # 1023089 and using the included soap dispenser. Lowe’s sells a similar product like this one but the tubing can’t be uncoiled without boiling the tubing in water for 5 minutes. This tubing is very high quality silicone and will NOT try to coil up like others do. I measured the connector and the tube on my soap dispenser before ordering to be sure it would fit. If the tubing doesn’t fit tightly it will allow air into the tube and you’ll have problems getting soap out. I slipped this tubing over the hard plastic tube on my soap dispenser again because I measured before ordering. If it didn’t fit tightly I would have tried a pipe clamp to help tighten it or replaced my dispenser with a known compatible model. I did have to pump it 450 times to get the soap all the way through the tubing but I should have sucked it through. The soap dispenser doesn’t provide much vacuum pressure. I tested it every 12 hours for 4 days and it always works on the 1st pump .this tubing needs to fit tightly onto your dispenser and if it doesn’t it’s your fault for taking bad measurements. I don’t care to see all these 1 star reviews all over Amazon for products that work . These reviewers make it impossible to know what products to buy. I got lucky and just bought this one dispite all the 1 star reviews I read on it.

A very simple product that works well! I wish I knew about this years ago because now I only change the soap bottle 1-2 times per year underneath my sink. This works very well, doesn't leak, and I've installed this on 2 sinks now, and bought one for a relative who also loves it. I just buy the big club-sized bottles of detergent now, and avoid messy fill-ups. I can highly recommend this dispenser kit.

I got tired of either crawling below the sink to take out and refill the soap bottle or, worse, trying to fill it from above (which is a guaranteed soapy mess). We saw a product similar to this in a short on social media and figured we'd look for one. So far, it's the best decision we've made in awhile. The Good: Pretty much everything. It was crazy easy to install, has a check valve so the soap doesn't retract back into the container between pumps, didn't take long at all for the initial prime, and delivers a reliable stream of soap. The Bad: Not really "bad" but it was a concern: the green silicon stoppers (two sizes are provided) fit the soap bottle perfectly; however, I expected the stopper to "grab" the hose a little better. Instead, the hose just passes right through with little resistance. It doesn't appear to affect performance, though. I guess I was just expecting more of an airtight seal. My biggest worry is that this might allow the hose to either come out of the bottle completely or just reposition itself enough that it stops drawing soap. Until that happens, though, I'll let it slide. The thing works. That's all that matters for now.

This worked great! Keep up the good work. This product fixed a ton of issues.

Easy to install and works great so far. The extension tube fit perfectly with my sink soap dispenser, and installation only took a few minutes. No leaks and it’s working as expected for now.

Needed this for my kitchen sink soap pump - fit and works great !!

This is an amazing solution. Our pricey in counter soap pump wouldn’t pump. I ordered this to replace the typical bottle installed under the counter. What an improvement. I don’t know why all manufacturers don’t switch to this design. We no longer have to dilute the soap in hopes that it will pump. This part is easy to install as long as you follow the directions. The stopper (3 sizes provided) for the bottle under the sink is a very firm fit, in case the bottle falls over. Now we have a club size soap bottle and refills will be infrequent.

It is really helpful but I feel its a little bit expensive but it is great idea and quality

Excellent product, easy to install, works perfectly