KAKA INDUSTRIAL Throatless Sheet Metal Shear, 20-Gauge Manual Bench Cutter MMS-4 for Steel, Aluminum, and Stainless Steel​

The cutter was shipped promptly. It was heavier and well constructed. It operates smoothly. I am more than satisfied with the quality. Good buy for the money.

Cuts smoothly and leaves a finished edge. I should have bough one of these years ago opposed to struggling with sheers. If you plan to use it often, I'd suggest getting the ratchet handle version, but for my infrequent use this low cost gear and latch version work fine.

Did not shear material like it said it would, the bottom wheel actually tipped immediately after going into the material & bound up underneath the top wheel instead of riding right beside like its supposed to causing the shearing action. Readjusted it several times & same result, cheap China junk don't buy it!

Appears to be good quality. Works good. I should have bought one of these earlier.

I bought this to cut some aluminum panels to replace all of the fence panels of my pontoon boat. I build a little jig so i could size them consistently. I easily cut 60 ft of 0.030" aluminum with ease!!! the edges had no crinkle or warping from the cutting and that was a huge concern for me. The alternate was to use tin shear and that would have been awful.

I have only tested it one time cutting off a cookie tin rim, but smooth as silk.

Junk total waste of money

at first worked great, then roller started getting loose and wouldnt cut anything. took apart and tried again. worked well again for about 2 weeks, now i have to take back part AGAIN and set it. the adjustment screws are garbage