skoko 2 Pack Full Body Protective Film Compatible with Rolex Oyster Perpetual Perpetual Datejust 41mm, Glossy Clear Skin, Full Coverage, Anti Scartch, Easy installation

1) no clear instructions to make the fluid , i had to watch other youtube videos and assume the liquid is made with detergent and water , would be nice if instructions were provided on how to make the fluid or provide the fluid itself for the price 2) some stickers just dont align , u can see the first three photos the sticker around the bezel didn't even cover the full bezel i have atleast 5 to 7 mm exposed make me think if they sent me the 36 mm stickers ??, the side edge stickers coming off the very next day. face and clasp seems to be ok so far , i have put on only these and it took more than an hour , i wish i could get a refund .

Folien passen nicht zu 100% Folien gucken an den Rändern drüber Wenn alle Folien verklebt sind schließt sich die Uhr nicht mehr durch die Folien dicke

Not a good product at all .. it doesn’t stick well…

Bought it for a gray dial 41mm dayjust with smooth bezel and oyster bracelet. It however is a bit tricky for first time users like me to apply it. But eventually I figured out how to use it. Hopefully my experience can help others. 1. Those plastic films do match very well with the watch. So make sure you order the right product and examine pieces to decide where they go on the watch. There are two round pieces, with the bigger one for a 41mm op with no cyclops eye. The smaller piece is for the case back for both op and dayjust. There is another round piece with a cut out which is for a dayjust. Other pieces are easier to figure out. I didn’t use the pieces for inside of the clasp. 2. To use the films properly understand that they are not sticky right after you take them out of the water. So you will have time to move it. The stickiness doesn’t come in for a good 4 and 5 minutes. For the crystal, just place the film on it and move around the film to make sure it covers the watch properly. After that I suggest not apply anything else. Wait for 4, 5 minutes to make sure the film is kinda dry and sticky and push the film firmly onto the watch before moving onto the next piece. For places like bezel and cyclops eye, it’s a bit tricky as they aren’t completely flat. Try the bezel first. Again put the film on move it around to make sure it covers the bezel properly, wait for 4, 5 minutes before push it down firmly to make sure it sticks. For the cyclops eye, the surface is curved. One needs to put the film on it but it won’t stick right away. So the film will kinda float only touching the center of the eye. Wait for 4, 5 minutes before pushing the edges down to meet the cyclops eye. You need to hold the film down for about 30 second to make sure it really sticks to the crystal. If the film isn’t sticky enough and moves around you have to wet it again in water and reapply it. The key is to position it right first then wait some time for it to become sticky before then press it firmly to make it stick to the watch. 3. The watch case back is similar to the cyclops eye so need to be patient. It is easier with the clasp and bracelet pieces as they have flat surfaces. 4. Make sure all film pieces are clean you can always wash it with water. And the watch should be clean. Press firmly at the corners and edges as that’s where dust might get it. Patience is key in this application. Took me two nights to get it done right. If you do it right you can hardly see the film.

انا طلبت ساعه ايش هذااات اريد ارجاعه