Waterproof Motorcycle Cover Replace for Honda CBR600RR CBR1000RR /CBR500R CBR650R CB1000R Sport/Standard Model, 420D Oxford Cloth Motorcycle Cover for Snow Rain Dust Protection

Replacement for my old cover on 85 Goldwing. This cover fits perfect. All the way to the ground, Nice black and red colors. Red is fading a bit after being out in the Texas sun for 7 months, but material is holding up well. Water proof, keeps bike clean and dry.

It fit perfectly

Awesome. I have 2 motorcycles so I bought 2. Love this

Perfect fit for my Honda Rebel 1100T DCT. I am hoping it is durable. But first try was great.

Good heavy but light weight Good quality.

This cover appears to be ok, but just got it. Its not really a canvas type fabric, it's more of a nylon'ish type material. Just a couple points: 1. The things they call vents are just a couple holes popped through the fabric.\ 2. The cover was stuck (melted) together so hard like rubber that sat too long smashed together that we had to leave it in the sun for a couple hours to try to soften it up...and then when we finally pulled it apart we were scared the whole time we were going to rip it, which we did in a couple small spots. And it took about 15 minutes just to carefully open it. Not sure yet, but the quality seems sub-par...but we'll see. maybe look at other options.

Keeps my bike dry and clean when not in use

My Valkyrie Standard has a small Fly Screen windshield, hard saddlebags and no rear rack or passenger saddle. This Cover fits just fine. It is literally 15F. outside in KC, so didn’t jack around much to get the cover fitted!!! The side Grey Reflective stripes basically align with the handgrips, while the lower most front of the Red vinyl aligns with the front tire. There is a single adjustment 1” strap just about where my kickstand lands on pavement. Toss it across and under the bike to the right side, grab it from there and connect to the Buckle Strap just below the Driver Foot Peg. NOW, the diagram shows the lower perimeter seam tension string access to be near the Front Tire. Not so much. Mine was located at the back, near the Rear Tire, just nearly aligned with the Wheel Axle. A better design would have been to have had TWO drawstrings, at both Front and Rear of the cover. At this stage, that’s the only knock I have so far. I did a find a couple of the “adhesive seams” mentioned in the Seller’s description, they appeared to be Clear Tape over a few intersecting seams. But man, I was getting frozen outside and had to rush it along for a closer inspection later on!!! Let’s see what the next few months of brutal Midwest winter and a Tornadic spring can do to it!