XBERSTAR Mini 3 Original Front/Rear Left/Right Motor Arm Replacement For DJI Mini 3 Drone (mini3 Right front arm)

As pictured. Be careful and sure to keep some wire pulled to motor to solder, then carefully push back into arm after insulated joints. Can keep some leads on old motor. Also was easier for me to cut and solder the motor wires just inside the body, vs reterminate at board. see youtube for good examples b4 you start.

I picked this up to replace a broken front motor arm on my DJI Mini 3, and it fit perfectly. The quality is solid, everything lined up with the original screw points, and the motor runs smooth with no vibration or wobble. My drone flew exactly like normal afterward. If you’re comfortable doing small repairs, this piece makes the process easy and saves you from paying for a full repair service. Great value, OEM-level fit, and my Mini 3 is back in the air without any issues. Definitely recommend.

It took a while for the part to come, but it came as advertised in pretty good packaging.

Item as described

Showed up broken the tiny plug on the end of gray wire had been crushed prior to me receiving packaging seemed fine. Completely unusable

No Antena, useless

Took forever to arrive and major difficult to install the motor on it

These are exactly what came on my drone originally. Now the installation was no easy task. Unless you are a do it yourself r with most everything, this might be out of some comfort zone. Just because you need to basically disassemble the entire front.

Ottimo grazie

Buono

7Braccetto drone inutilizzabile in quanto manca il filo dell'antenna. Dovrebbero uscire 7 fili: 3 del motore, 3 per i led e 1 per l'antenna. Il braccetto è tutto un blocco e la mancanza dell'antenna non può essere sistemata. 1 stella per avermi fatto perdere tempo. Visto il prezzo di quasi 80 euro bisognava fare un controllo certosino prima di metterlo in vendita. Ho avviato il reso.