DIMM 32 GB DDR5-6000 (2x 16 GB) Dual-Kit (grau, FLESD532G6000HC30DC01, VULCAN ECO, INTEL XMP, AMD EXPO)

Ich hatte vorher 32 GB RAM Arbeitsspeicher und habe den gleichen RAM Speicher nachgekauft und auf 64 GB RAM Arbeitsspeicher erweitert. Der Einbau ist sehr leicht. Der Rechner hat den neuen Arbeitsspeicher sofort erkannt. Kurz nach dem starten des PC in Bios speichern und fertig.

works great and exactly what i was looking for

شغال وكويس وصلني سليم

Ottime

Besides my fans being an absolute eye sore, I did match my ram to this build. These stick are on the MSI support list for the Project Zero board I am using in my Jonsbo D32PRO. Originally it did look awesome with the all black/silver design. But that was ruined when my Arctic Liquid Freezer III 240mm AIO wasn't working properly. Seriously bad noise coming from it. I concluded that it couldn't be the the pump because I had adjusted power to pump to slow it down but the sound remained. Turned fans up and down and audio of the noise would occur. Replaced the fans with Arctic P12PRO fans and the sound remained. Installed my Noctua fans (same in my image) knowing they were in perfect health. And sure enough, the noise was still there. Checked the fin stack to see if any fins were bent or squished causing the noise, nope. Fins were perfect could see right through with no serious obstructions.... So because I had to replace that, I ended up going with all Noctua fans, which I had in stock. The only extra purchase was the two NF-A12x15 slim fans I bought for the bottom. I could have wedged full size 25mm thick fans down there, but chose against it. I know how turbulent airflow can get when you have two fans side by side, so preferred the thin fans to have that gap. Also the fans are installed closest to the glass door side (camera side) so that it can help push airlow up toward the top to exit through rear/top/psu. It works. For those wondering, YES, this is the Jonsbo D32PRO case. Yes, that is a 7900xtx red devil and it fits.... its a 3.5 slot card. But that's because the MSI Project Zero B650M board has the x16 slot at the very top of the 4 slots. While many m-atx boards have the x16 slot in the 2nd position of the 4.... Yes, this case supports back connect, as you can tell since there are no cables to be seen except for the GPU. YES, that is an extra long full size PSU (corsair RM1000X SHIFT) and the reason it also fits is because instead of the cables coming out the bottom they come out the side, which in my build means the back side. so all cables are legit on the back of the system minus the liquid cooler which I routed down below the memory (you can see it around the one screw, not tight and routed after installing the screw). You can see the silver ram REALLY fits with this motherboard. A killer combo for sure. Running full rated speed, can't complain.