Maddog 36" Stainless Steel HPA Fill Whip Hose Extension - 4500 PSI Airsoft, Paintball, PCP Airgun Tank Charging System - Quick Connect 1/8" Male & Female

The first hose that I received was severely damaged due to the fact that the end with female quick disconnect coupler was literally crushed! The damaged hose was promptly replaced by this vendor and upon inspection, the new one appears very well made and fits as it should on both ends. I have not tested it for leakage yet

I have a Crosman 1701P with a male fosters fitting on the end. I added a LDC and that made it impossible to foil my gun as I have an blind water filter that won't fit in the limited clearance. I added this SS whip as it was cheaper than buying and extension or new fittings to re-configure my current set-up. This came with fittings already installed and was a true plug and play solution. Whip is super well built and should last me a lifetime. At this price you can pick up a couple for any HPA needs (seriously just price out what a male and female fitting cost and this is as cheap and you get the hose!)

It's a bit*h to unscrew the quick release to attach it to the other end, so I can actually attach it to my CO2 tank & regulator.. but once it's done.. it does great.. the inability to unscrew it with pliers & a wrench sucked.. but we figured it out

Arrived on time very good and fast service !!!!

Usually, the compressor line for PCP air rifle charging is too short. This really makes life easy when filling my air rifles.

Great quality works great

Purchase this to replace crappy hose on Hill MK4 air pump works good. You can remove the male fitting and screw it right into the pump. As long as you're pumping no leaks . But if you leave the pump hooked up, thinking you're going to pump a while and come back it will drain down to zero don't know if it's the pump or the hose still a good replacement on the hill MK4 pump. By the way carpet in my shop not the house.

The female quick connect would not fit any of the three foster fittings I have. The male end was OK, but the female would not seat so the locking ring could lock. With the high pressure from my pump, this is not safe. Returned