BIOWIND Quiet Register Booster Fan Fits 4" x 10" Register Holes, 10-Speed Smart Heating Cooling AC Vent Fan with Remote Control and Thermostat Control - Bronze

It's ok, doesnt have as much power as we were hoping. We will see in the summer of it does what we want it to do.

I have an upstairs that runs too warm all summer. It's big room with one vent fed by at least a 15 foot run of 12" duct. I had been planning to sever the duct and install an inline duct fan up in the attic and either use an expensive pressure switch or tap into the thermostat wire with a relay, but this vent register booster is a much easier to install and less expensive solution - and it's working pretty well! Plugging it in is the only tricky part, but I was able to plug it in up in the attic so no cord is visible. I took my old vent register off and I probed around the edges with one of those wiring fishing rods until I found a gap where the rod could push up into the attic. Then I climbed up in the attic, plugged it into an outlet up there and then taped the end of the cord to the rod so I could pull it back down into the room. The AC register booster has a short 6 inch lead attached to it, and the rest of the wire connects to that. It's obviously heavier than a plain vent register, so it was bit difficult to install because I had to use both hands to hold the register up there and connect the wire and then reach for the screw and screwdriver to fasten it in place without letting go of anything. The thermostat measures the air in the duct so that you can set it a temperature below the normal room temperature, but above the temperature you're reading in the vent when the AC is on and it will turn the fans on only once the cold air starts coming through. Mine started off reading 68ºF in the duct, but after a while I checked it again and the reading was 66º, so I figure it's pulling the cool air through the duct faster and not allowing it to heat up in that long duct in the attic. I still need to replace my AC system, but I can tell that this room is noticeably more comfortable after installing this inexpensive solution first.

I want to improve cooling on the 2nd floor. My house has one central air conditioner with ducts and one controller on the main floor. I installed 3 register fans, one in each bedroom on the 2nd floor of a 2 storey house. Cooling on the 2nd floor has improved. These register fans are quiet on speed settings 1 to 5. Build quality looks good.

I have grown to love these... if you want a little boost, you can get them down to quite quiet, if you need to pull more air it can do that too, and still quite manageable. I like how it turns on and off when the a/c or heat is on! The casing is attractive, and the display turns off when you're not using it (so no extra light in the room when trying to sleep). Good job folks. Simple, reliable and attractive.

Exactly what we needed for the upstairs bedroom! They pull more of the AC cool air up to the room and keeps the rooms cooler. We can raise the temp in our thermostat as these little fans are keeping the rooms at our preferred temp. They are easy to install and setup as long as you follow the directions. We’ve been running one in each bedroom for about a month now and at full fan speed (10) with no issues. The power cord is long enough to reach an outlet. Highly recommend as these are a great value and work as described. The remote works fine, but I just don’t use it as it’s easy enough to adjust settings on the register.